Book contents
- Frontmatter
- Contents
- Preface
- 1Introduction
- 2Notation
- 3Hover
- 4Vertical Flight
- 5Forward Flight Wake
- 6Forward Flight
- 7Performance
- 8Design
- 9Wings and Wakes
- 10Unsteady Aerodynamics
- 11Actuator Disk
- 12Stall
- 13Computational Aerodynamics
- 14Noise
- 15Mathematics of Rotating Systems
- 16Blade Motion
- 17Beam Theory
- 18Dynamics
- 19Flap Motion
- 20Stability
- 21Flight Dynamics
- 22Comprehensive Analysis
- Index
- References
12 - Stall
Published online by Cambridge University Press: 05 May 2013
Book contents
- Frontmatter
- Contents
- Preface
- 1Introduction
- 2Notation
- 3Hover
- 4Vertical Flight
- 5Forward Flight Wake
- 6Forward Flight
- 7Performance
- 8Design
- 9Wings and Wakes
- 10Unsteady Aerodynamics
- 11Actuator Disk
- 12Stall
- 13Computational Aerodynamics
- 14Noise
- 15Mathematics of Rotating Systems
- 16Blade Motion
- 17Beam Theory
- 18Dynamics
- 19Flap Motion
- 20Stability
- 21Flight Dynamics
- 22Comprehensive Analysis
- Index
- References
Summary
To maintain low drag and high lift, the flow over an airfoil section must remain smooth and attached to the surface. This flow has a rapid acceleration around the nose of the airfoil to the point of maximum suction pressure, and then a slow deceleration along the remainder of the upper surface to the trailing edge. The deceleration must be gradual for the flow to remain attached to the surface. At a high enough angle-of-attack, stall occurs: the deceleration is too large for the boundary layer to support, and the flow separates from the airfoil surface. The maximum lift coefficient at stall is highly dependent on the Reynolds number, Mach number, and the airfoil shape. Figure 8.12 shows clmax values from 1.0 to 1.6 for various airfoils, corresponding to stall angles-of-attack of 10° to 16°. The unstalled airfoil has a low drag and a lift coefficient linear with angle-of-attack. The airfoil in stall at high angles-of-attack has high drag, a loss of lift, and an increased nose-down pitch moment caused by a rearward shift of the center of pressure. The aerodynamic flow field of an airfoil or wing in stall is complex, and for the rotary wing there are important three-dimensional and unsteady phenomena as well.
Information
- Type
- Chapter
- Information
- Rotorcraft Aeromechanics , pp. 442 - 461Publisher: Cambridge University PressPrint publication year: 2013
References
, “A Simplified Theoretical Method of Determining the Characteristics of a Lifting Rotor in Forward Flight.” NACA Report 716, 1941.Google Scholar
“A Qualitative Examination of Dynamic Stall from Flight Test Data.” Journal of the American Helicopter Society, 43:4 (October 1998).CrossRefGoogle Scholar
“Evaluation of Airfoil Dynamic Stall Characteristics for Maneuverability.” Journal of the American Helicopter Society, 46:4 (October 2001).CrossRefGoogle Scholar
, , and “Analysis of the Development of Dynamic Stall Based on Oscillating Airfoil Experiments.” NASA TN D-8382, January 1977.Google Scholar
, , and “An Exploratory Aerodynamic Limits Test with Analytical Correlation.” American Helicopter Society 4th Decennial Specialist's Conference on Aeromechanics, San Francisco, CA, January 2004.Google Scholar
“Aerodynamic Efficiency Potential of Rotary Wing Aircraft.” American Helicopter Society 16th Annual National Forum, Washington, DC, May 1960.Google Scholar
“A Mathematical Model of Unsteady Aerodynamics and Radial Flow for Application to Helicopter Rotors.” USAAVLABS TR 72-67, May 1973.Google Scholar
, , and “Measurements of the Dynamic Stall Vortex Convection Speed.” Seventeenth European Rotorcraft Forum, Berlin, Germany, September 1991.Google Scholar
, and “Effect of Blade Stalling on the Efficiency of a Helicopter Rotor as Measured in Flight.” NACA TN 1250, April 1947.Google Scholar
“The Bristol 171 Helicopter.” The Journal of the Royal Aeronautical Society, 53:460 (April 1949).CrossRefGoogle Scholar
, and “Dynamic Stall Considerations in Helicopter Rotors.” Journal of the American Helicopter Society, 13:2 (April 1968).CrossRefGoogle Scholar
, and “Torsional Oscillation of Helicopter Blades due to Stall.” Journal of Aircraft, 3:3 (May-June 1966).CrossRefGoogle Scholar
“Rotary Wing Aerodynamics – Historical Perspective and Important Issues.” American Helicopter Society National Specialists' Meeting on Aerodynamics and Aeroacoustics, Arlington, TX, February 1987.Google Scholar
, , and , “Rotor High Speed Performance, Theory vs. Test.” Journal of the American Helicopter Society, 15:3 (April 1970).CrossRefGoogle Scholar
“Rotorcraft Aerodynamic Models for a Comprehensive Analysis.” American Helicopter Society 54th Annual Forum, Washington, DC, May 1998.Google Scholar
, and “A Generalised Model for Airfoil Unsteady Aerodynamic Behaviour and Dynamic Stall Using the Indicial Method.” American Helicopter Society 42nd Annual Forum, Washington DC, June 1986.Google Scholar
, and “A Semi-Empirical Model for Dynamic Stall.” Journal of the American Helicopter Society, 34:3 (July 1989).CrossRefGoogle Scholar
, and , “State-Space Model for Unsteady Airfoil Behavior and Dynamic Stall.” AIAA Paper No. 89-1319, April 1989.CrossRefGoogle Scholar
, and “Wind-Tunnel Tests of a Full-Scale Helicopter Rotor with Symmetrical and with Cambered Blade Sections at Advance Ratios from 0.3 to 0.4.” NACA TN 4367, September 1958.Google Scholar
, and , “Detailed Aerodynamic Measurements on a Model Rotor in the Blade Stall Regime.” Journal of the American Helicopter Society, 17:1 (January 1972).Google Scholar
, and “Viscous-Inviscid Interaction on Oscillating Airfoils in Subsonic Flow.” AIAA Journal, 20:2 (February 1982).Google Scholar
“What Are the Lift and Propulsive Force Limits of High Speed for the Conventional Rotor?” American Helicopter Society 34th Annual National Forum, Washington, DC, May 1978.Google Scholar
, , , and “An Experimental Analysis of Dynamic Stall on an Oscillating Airfoil.” Journal of the American Helicopter Society, 19:1 (January 1974).CrossRefGoogle Scholar
, , , and “Full-Scale Wind Tunnel Test of the UH-60A Airloads Rotor.” American Helicopter Society 67th Annual Forum, Virginia Beach, VA, May 2011.Google Scholar
“Toward a Unified Lift Model for Use in Rotor Blade Stability Analyses.” Journal of the American Helicopter Society, 30:3 (July 1985).CrossRefGoogle Scholar
“Progress in the Semi-Empirical Prediction of the Aerodynamic Forces due to Large Amplitude Oscillations of an Airfoil in Attached or Separated Flow.” Ninth European Rotorcraft Forum, Stresa, Italy, September 1983.Google Scholar
“Dynamic Stall Modeling of the NACA 0012 Profile.” La Recherche Aerospatiale, 1984:6 (1984).Google Scholar
“Differential Equation Modeling of Dynamic Stall.” La Recherche Aerospatiale, 1989:5 (1989), corrections dated October 1990.Google Scholar
“An Investigation of Stall on a 4.2m Diameter Experimental Rotor.” Seventh International Workshop on Dynamics and Aeroelastic Modeling of Rotorcraft, St. Louis, MO, October 1997.Google Scholar
“Aerodynamic Parameters Selection in Helicopter Design.” Journal of the American Helicopter Society, 5:1 (January 1960).CrossRefGoogle Scholar
Introduction to Helicopter Aerodynamics. Morton, PA: Rotorcraft Publishing Committee, 1955 (first edition 1950).Google Scholar
“Charts for Estimating Rotary Wing Performance in Hover and at High Forward Speeds.” NASA CR 114, November 1964.Google Scholar
, “Prediction of Control Loads Due to Blade Stall.” Journal of the American Helicopter Society, 17:2 (April 1972).CrossRefGoogle Scholar
“Calculation of Rotor Performance and Loads Under Stalled Conditions.” American Helicopter Society 59th Annual Forum, Phoenix, AZ, May 2003.Google Scholar
Accessibility standard: Unknown
Why this information is here
This section outlines the accessibility features of this content - including support for screen readers, full keyboard navigation and high-contrast display options. This may not be relevant for you.Accessibility Information
Accessibility compliance for the PDF of this chapter is currently unknown and may be updated in the future.