Hostname: page-component-7b7567c8c-tnkh4 Total loading time: 0 Render date: 2026-11-18T03:25:42.311Z Has data issue: false hasContentIssue false

Residual Stresses in Aluminum-Mullite (α-Alumina) Composites*

Published online by Cambridge University Press:  06 March 2019

Davor Balzar
Affiliation:
Materials Science and Engineering Laboratory, National Institute of Standards and Technology, Boulder, Colorado 80303
Hassel Ledbetter
Affiliation:
Materials Science and Engineering Laboratory, National Institute of Standards and Technology, Boulder, Colorado 80303
Get access

Abstract

We studied particle-reinforced 6061-aluminum-alloy composites with particle volume fractions ranging from 0 to 0.25. The mullite particles are approximately spherical and contain embedded α-alumina phase. We obtained lattice parameters of all three phases in the composites and starting materials by using Rietveld refinement of x-ray diffraction patterns. In all three phases stresses are tensile and approximately of the same magnitude, contradicting a requirement for mechanical equilibrium. Stresses increase with both increasing particle size and volume fraction. Measurements of extracted-from-composites particles showed no evidence of a possible chemical reaction at the matrix-particle interface. The matrix is [111] and [100] textured, but measurements of elastic constants reveal only small anisotropy. Thus, explanation of the mechanical-equilibrium violation remains uncertain.

Information

Type
IX. Stress and Strain Determination by Diffraction Methods, Peak Broadening Analysis
Copyright
Copyright © International Centre for Diffraction Data 1992

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable