Hostname: page-component-7b7567c8c-2jgqx Total loading time: 0 Render date: 2026-11-19T20:16:59.768Z Has data issue: false hasContentIssue false

Effect of Macro and Micro Stresses on Hardness of Titanium Aluminides

Published online by Cambridge University Press:  06 March 2019

Hiroyuki Tabata
Affiliation:
Industrial Research Institute of Ishikawa Ro-1 Tomizu-machi, Kanazawa 920-02, Japan
Zenjiro Yajima
Affiliation:
Department of Mechanical Engineering, Kanazawa Institute of Technology, 7-1 Oogigaoka, Nonoichi, Kanazawa 921, Japan
Yukio Hirose
Affiliation:
Department of Material Science and Engineering, Kanazawa University, Kakuma-machi, Kanazawa 920-11, Japan
Get access

Abstract

The changes in micro structure and hardness of massively transformed Ti-48mol%Al alloys with tempering were investigated. The results were correlated to the X-ray profile analysis. The integral width of Cu-kα1 net peak especially from γ (111) plane related well to the hardness change. Hall plots suggested that lattice strains are released by spheroidizing with the recovery at low temperature and then small particles grow at higher temperatures, as might support the microstructural change. The small particle size is therefore presumed to be the controlling factor for the hardness. Macro stress is shown not to affect the hardness as much.

Information

Type
Research Article
Copyright
Copyright © International Centre for Diffraction Data 1995

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable