Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-17T00:35:56.904Z Has data issue: false hasContentIssue false

Energy Dispersive Diffraction in a Diamond Anvil High Pressure Cell Using Synchrotron and Conventional X-Radiation

Published online by Cambridge University Press:  06 March 2019

David R. Black
Affiliation:
Department of Physics, Colorado State University, Fort Collins, Colorado 80523
Carmen S. Menoni
Affiliation:
Department of Physics, Colorado State University, Fort Collins, Colorado 80523
Ian L. Spain
Affiliation:
Department of Physics, Colorado State University, Fort Collins, Colorado 80523
Get access

Extract

A wide range of structural studies have been carried out in high pressure diamond anvil cells using x-rays. The most common experimental geometry is shown in Fig. 1a. The incident x-ray beam passes axially through the first diamond and enters the sample, typically 100-300 μm in diameter and 20-100 μm thick; the diffracted x-rays exit via the second diamond. Energy-dispersive detection techniques (EDXRD) have been used. However the intensity of diffracted radiation from the sample is weak, so that typical exposure times with a conventional, fixed anode, x-ray source are typically one to several days.Accordingly, higher intensity radiation from synchrotron sources has been used for these experiments.

Information

Type
III. Position Sensitive Detectors and X-Ray Instrumentation
Copyright
Copyright © International Centre for Diffraction Data 1983

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable