Hostname: page-component-6898cfcb55-th4rj Total loading time: 0 Render date: 2026-11-11T20:27:08.515Z Has data issue: false hasContentIssue false
  • English
  • Français

The Preparation of Pole Figures for Polymers by Computer Techniques

Published online by Cambridge University Press:  06 March 2019

J. W. Jones
J. W. Jones*
Affiliation:
E. I. du Pont de Nemours and Co., Inc. Wilmington, Delaware
Get access

Abstract

Preferred orientation in polymers has been studied by preparation of pole figures. The diffraction data are collected on punch tape under the control of a programmer for the orienter which permits step wise or continuous scanning. A computer is programmed to prepare the data for an off-line automatic curve plotter. Several projections are available.

Information

Type
Research Article
Information
Advances in X-Ray Analysis , Volume 6: Eleventh Annual Conference on Applications of X-ray Analysis, August 8-10, 1962 , 1962, pp. 223 - 230
Copyright
Copyright © International Centre for Diffraction Data 1962

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable

References

1. Geisler, A. H., “Crystal Orientation and Pole Figure Determination,” Modern Research Techniques in Physical Metallurgy, ASM Cleveland, 1953, pp. 131-153.Google Scholar
2. Holland, J. R., Engler, N., and Powers, W., “The Use of Computer Techniques to Plot Pole Figures,” Advances in X-ray Analysis, Vol. 4, University of Denver, Plenum Press, New York, 1961, pp. 74–84.Google Scholar
3. Furnas, T. C. Jr., Single-Crystal Orienter Instruction Manual, General Electric Company, Milwaukee, Wise, 1957.Google Scholar
4. Heffelfinger, C. J. and Burton, R. L., “X-ray Determination of the Crystallite Orientation Distribution of Polyethylene Terephthalate Films,” J. Polymer Sci. 48: 289, 1960.Google Scholar
5. Holden, A. N., “A Spiral-Scanning X-ray Reflection Goniometer for the Rapid Determination of Preferred Orientations,” Rev. Sci. Instr. 24: 10, 1953.Google Scholar
6.ASTM E-81-54T, “Tentative Method for Preparing Quantitative Pole Figures of Metals,” ASTM Specifications, Vol. 3, 1961, pp. 780-795.Google Scholar