Hostname: page-component-7b7567c8c-fvjsw Total loading time: 0 Render date: 2026-11-16T08:28:42.301Z Has data issue: false hasContentIssue false

X-Ray Fluorescence Analysis of Refractory Oxide Materials

Published online by Cambridge University Press:  06 March 2019

Subrata Banerjee
Affiliation:
General Refractories Company Research Center Baltimore, Maryland 21203
Ben G. Olsen
Affiliation:
General Refractories Company Research Center Baltimore, Maryland 21203
Get access

Abstract

In a refractory manufacturing industry with widely diversified products from silica (SiO2 ≥ 90%) to high alumina materials (Al2O3 ≥ 90%) and basic refractory from periclase (MgO ≥ 95%) to chrome-periclase (Cr2O3 ≤ 40%) mixtures, introduction of a single method of analysis is impractical both economically and precision-wise. Three different methods are proposed with a view to realistic needs: (a) Direct ratio method, (b) calibration curve ratio method, and (c) matrix normalization by fusing with Li2B4O7 and La2O3 into a glass bead followed by grinding and pelletizing. Statistical regression equations were used for the calibration curves from available NBS standards 15-20 samples previously analysed by wet chemical methods by ratioing with relevant reference samples. In most cases, the relative standard deviation was 2 - 8%.

Information

Type
Research Article
Copyright
Copyright © International Centre for Diffraction Data 1974

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable