Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-18T01:21:17.588Z Has data issue: false hasContentIssue false

Incompressible flow past a flat plate aerofoil with leading edge separation bubble

Published online by Cambridge University Press:  04 July 2016

B. G. Newman
Affiliation:
Department of Mechanical EngineeringMcGill University, Montreal
M-C. Tse
Affiliation:
Department of Mechanical EngineeringMcGill University, Montreal

Summary

A simple flow model has been developed to predict the size of the separation bubble which forms at the sharp leading edge of a flat plate aerofoil at incidence a which are less than about 8°, and the corresponding lift and drag coefficients. This flow model is based on irrotational flow and source singularities which are determined indirectly from experiment. The bubble length is shown to be proportional to α2with a slope which depends on the rate of growth of the separated shear layer. A thin double-wedge aerofoil has been tested in a wind tunnel. It is concluded that these and previous measurements agree fairly well with the theory for chord Reynolds numbers greater than about 0.5 × 106.

Information

Type
Research Article
Copyright
Copyright © Royal Aeronautical Society 1992 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable