Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-16T15:25:51.988Z Has data issue: false hasContentIssue false

The aerodynamic optimisation of a low-Reynolds paper plane with adjoint method

Published online by Cambridge University Press:  24 August 2020

Y. Zhang*
Affiliation:
State Key Laboratory of Mechanical Structure Strength and Vibration, Xi’an Jiaotong University, Xi’an, China
X. Zhang
Affiliation:
State Key Laboratory of Mechanical Structure Strength and Vibration, Xi’an Jiaotong University, Xi’an, China
G. Chen
Affiliation:
State Key Laboratory of Mechanical Structure Strength and Vibration, Xi’an Jiaotong University, Xi’an, China
Rights & Permissions [Opens in a new window]

Abstract

The aerodynamic performance of a deployable and low-cost unmanned aerial vehicle (UAV) is investigated and improved in present work. The parameters of configuration, such as airfoil and winglet, are determined via an optimising process based on a discrete adjoint method. The optimised target is locked on an increasing lift-to-drag ratio with a limited variation of pitching moments. The separation that will lead to a stall is delayed after optimisation. Up to 128 design variables are used by the optimised solver to give enough flexibility of the geometrical transformation. As much as 20% enhancement of lift-to-drag ratio is gained at the cruise angle-of-attack, that is, a significant improvement in the lift-to-drag ratio adhering to the preferred configuration is obtained with increasing lift and decreasing drag coefficients, essentially entailing an improved aerodynamic performance.

Information

Type
Research Article
Copyright
© The Author(s), 2020. Published by Cambridge University Press on behalf of Royal Aeronautical Society
Figure 0

Figure 1.Disposable paper UAV.(3)

Figure 1

Figure 2.An example of the FFD technique applied to the 3D wing deformation.

Figure 2

Figure 3.The detailed geometric size of model used in present work.

Figure 3

Figure 4.The control box and point around the surface mesh.

Figure 4

Figure 5.Details of the grid for the paper plane. (a) Surface mesh. (b) The refinements for the near-wall region.

Figure 5

Figure 6.Aerodynamic performance of the baseline paper plane. (a) Lift curve. (b) Drag curve. (c) Flow stream traces.

Figure 6

Figure 7.Optimisation for the profiles. (a) Lift curve (b) Drag curve (c) Lift-to-drag ratio.

Figure 7

Figure 8.Optimisation for the profiles. (a) Baseline. (b) Optimization.(c) Baseline (d) Optimization.

Figure 8

Figure 9.Comparison of profiles and surface pressure coefficient at the locations of y = 0.02m, 0.06m and 0.1m($\alpha $= 4deg).

Figure 9

Figure 10.Comparison of profiles and surface pressure coefficient at the locations of y = 0.02m, 0.06m and 0.1m($\alpha $= 14deg).

Figure 10

Figure 11.The stream traces on winglet of different model at 4deg. (a) Baseline (b) Optimization.

Figure 11

Figure 12.Comparison of line type of leading edge and near-wall path lines at $\alpha $= 14deg.

Figure 12

Table 1Comparison between the baseline and optimised model

Figure 13

Figure 13.Optimisation for the winglet and leading-edge line type. (a) Lift curve. (b) Drag curve (c) Lift-to-drag ratio