Hostname: page-component-7b7567c8c-w7t8q Total loading time: 0 Render date: 2026-11-18T07:14:53.027Z Has data issue: false hasContentIssue false

An alternative approach to evaluate fuel/air mixing quality

Published online by Cambridge University Press:  14 May 2021

L.-Y. Jiang*
Affiliation:
Aerospace Research Center National Research Council of Canada Ottawa Canada
Rights & Permissions [Opens in a new window]

Abstract

A practical method to evaluate quantitatively the uniformity of fuel/air mixing is essential for research and development of advanced low-emission combustion systems. Typically, this is characterised by measuring an unmixedness parameter or a uniformity index. An alternative approach, based on the fuel/air equivalence ratio distribution, is proposed and demonstrated in a simple methane/air venturi mixer. This approach has two main advantages: it is correlated with the fuel/air mixture combustion temperature, and the maximum temperature variation caused by fuel/air non-uniformity can be estimated. Because of these, it can be used as a criterion to check fuel/air mixing quality, or as a target for fuel/air mixer design with acceptable maximum temperature variation. For the situations where the fuel/air distribution non-uniqueness issue becomes important for fuel/air mixing check or mixer design, an additional statistical supplementary criterion should also be used.

Information

Type
Research Article
Copyright
© The Author(s), 2021. Published by Cambridge University Press on behalf of Royal Aeronautical Society
Figure 0

Figure 1.Geometry of the venturi methane/air mixer.

Figure 1

Figure 2.Computational domain and mesh.

Figure 2

Table 1Boundary conditions

Figure 3

Figure 3.Methane/air adiabatic flame temperature vs equivalence ratio.

Figure 4

Figure 4.Contours of velocity magnitude, axial component and methane mole fraction at the longitudinal symmetric plane.

Figure 5

Figure 5.Magnified views of velocity magnitude, axial component and methane mole fraction around the mixer throat.

Figure 6

Figure 6.Φ and corresponding T distributions at Z = 300 mm.

Figure 7

Figure 7.Φ and corresponding T distributions at Z = 400 mm.

Figure 8

Figure 8.Φ and corresponding T distributions at Z = 500 mm.

Figure 9

Figure 9.Φ and corresponding T distributions at Z = 800 mm.

Figure 10

Figure 10.Φ and corresponding T distributions at Z = 1150 mm.

Figure 11

Table 2NI, NIsup, $\Delta$T and ∼$\Delta$T at Z = 300, 400, 500, 800 and 1150 mm cross-sections

Figure 12

Figure 11.Local fuel mole fraction variance distribution at Z = 300 and 500 mm.

Figure 13

Figure 12.Local fuel mole fraction variance distributions at Z = 800 and 1150 mm.

Figure 14

Table 3U, UI, NI and NIsup at Z = 300, 400, 500, 800 and 1150 mm cross-sections