Hostname: page-component-74656f9884-rdgjk Total loading time: 0 Render date: 2026-11-08T04:57:36.550Z Has data issue: false hasContentIssue false
  • English
  • Français

An Analysis of Flexural Systems under Arbitrary Distortion and End Loading

Published online by Cambridge University Press:  28 July 2016

P. J. Midgley
P. J. Midgley*
Affiliation:
Wind Tunnel Department,English Electric Co. Ltd., Aircraft Division
Get access Rights & Permissions [Opens in a new window]

Summary

The effects of end loading on an arbitrarily distorted flexing beam are investigated, with particular reference to bending moment distributions along the span of the beam, and the effects of lengthwise strains. Cross-spring and “ spider ” type flexural systems are treated in detail. Curves are presented which enable the stiffness and stressing of any flexural system to be calculated for any loading conditions, subject only to the restriction that deflections are small, so that the linearised beam equation may be applied.

Information

Type
Research Article
Information
The Aeronautical Journal , Volume 61 , Issue 559 , July 1957 , pp. 475 - 484
Copyright
Copyright © Royal Aeronautical Society 1957

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable

References

1. Geary, P. J. (1954). Flexure Devices: Pivots, Movements and Suspensions. B.I.S.R.A., 1954.Google Scholar
2. Wittrick, W. H. (1948). The Theory of Symmetrical Crossed Flexure Pivots. Australian Journal of Scientific Research, Series A, Vol. i, No. 2, June 1948.Google Scholar
3. Haringk, J. A. (1949). The Cross-Spring Pivot as a Constructional Element. Applied Scientific Research, A Vol. I, No. 4, 1949.Google Scholar
4. Nickols, L. W. and Wunsch, H. L. (1951). Design Characteristics of Cross Spring Pivots. Engineering, 12th October 1951.Google Scholar
5. Wittrick, W. H. (1951). The Properties of Crossed Flexure Pivots and the Influence of the Point at Which the Strips Cross. The Aeronautical Quarterly, Vol. II, Part IV, February 1951.Google Scholar