Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-16T02:09:41.828Z Has data issue: false hasContentIssue false

The assessment of boundary layer two-dimensionality

Published online by Cambridge University Press:  04 July 2016

C. J. Fraser*
Affiliation:
Department of Mechanical and Industrial Engineering, Dundee College of Technology

Summary

The results of an experimental evaluation of three assessment criteria for boundary layer two-dimensionality are presented. The criteria include the so-called ‘two pin test', the momentum balance principle and the cross-stream variation in local skin friction coefficient. Extensive spanwise measurements in the flows investigated highlight the relative merits and limitations of the criteria imposed.

The momentum balance method is found to be the most informative technique, with the proviso that the test data must be interpreted with some care if measurements are restricted along a single streamwise axis.

The two pin test is found to provide a worthwhile complimentary addition to momentum balance data, whereas the spanwise variation in local skin friction coefficient is less conclusive as regards flow two-dimensionality.

Excepting the case of adverse pressure gradient flows, the momentum balance equation is seen as a viable experimental means of estimating the local skin friction coefficient in boundary layers where measurement is problematical, as in the case of transitional boundary layers. In such cases, the two pin test could be used as the sole means of confirming the flow two-dimensionality.

Information

Type
Research Article
Copyright
Copyright © Royal Aeronautical Society 1986 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable