Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-16T20:34:40.982Z Has data issue: false hasContentIssue false

Experimental investigation on wall pressure distribution in flaps’ separating regions

Published online by Cambridge University Press:  03 February 2016

P. F. Zhang
Affiliation:
Institute of Fluid Mechanics, Beijing University of Aeronautics and Astronautics, Beijing, Peoples Republic of China
J. J. Wang
Affiliation:
Institute of Fluid Mechanics, Beijing University of Aeronautics and Astronautics, Beijing, Peoples Republic of China
Y. C. Li
Affiliation:
Institute of Fluid Mechanics, Beijing University of Aeronautics and Astronautics, Beijing, Peoples Republic of China
Rights & Permissions [Opens in a new window]

Abstract

Core share and HTML view are not available for this content. However, as you have access to this content, a full PDF is available via the 'Save PDF' action button.

The effects on the wall pressure of the plate caused by the introduction of a gap near the ground and the flaps were investigated experimentally. The mean pressure on the plate surface was found to decrease with the size changing of the gap near the ground when the gap size (g) is larger than the flap height (h), but the one in the recirculation region increase with the size of the gap when the gap size is about 0 ≤ g ≤ 2h. Three kinds of flow structure appear with increasing the gap sizes, and the transit point is at g/h = 0·2, 0·8 respectively. For the zigzag flap (d/h = 0·19, d is the height of the zigzag), the variation of wall pressure with g/h is similar to the flat flap in general. The zigzag affects the mean wall pressure in the region of 0 ≤ x/h ≤ 20 (the recirculation zone) and can decrease the fluctuating pressure in the region of x/h > 20 downstream.

Information

Type
Research Article
Copyright
Copyright © Royal Aeronautical Society 2004