Hostname: page-component-7b7567c8c-7pwfn Total loading time: 0 Render date: 2026-11-16T08:33:41.984Z Has data issue: false hasContentIssue false

Influence of weight modelling on the outcome of wing design using multidisciplinary design optimisation techniques

Published online by Cambridge University Press:  27 January 2016

J. Mariens
Affiliation:
Faculty of Aerospace Engineering, Delft University of Technology, The Netherlands
A. Elham*
Affiliation:
Faculty of Aerospace Engineering, Delft University of Technology, The Netherlands
M. J. L. van Tooren
Affiliation:
Faculty of Aerospace Engineering, Delft University of Technology, The Netherlands
Rights & Permissions [Opens in a new window]

Abstract

Core share and HTML view are not available for this content. However, as you have access to this content, a full PDF is available via the 'Save PDF' action button.

Weight estimation methods are categorised in different classes based on their level of fidelity. The lower class methods are based on statistical data, while higher class methods use physics based calculations. Statistical weight estimation methods are usually utilised in early design stages when the knowledge of designers about the new aircraft is limited. Higher class methods are applied in later design steps when the design is mature enough. Lower class methods are sometimes preferred in later design stages, even though the designers have enough knowledge about the design to use higher class methods. In high level multidisciplinary design optimisation (MDO) fidelity is often sacrificed to obtain models with shorter computation times. There is always a compromise required to select the proper weight estimation method for an MDO project.

An investigation has been performed to study the effect of using different weight estimation methods, with low and medium levels of fidelity, on the results of a wing design using multidisciplinary design optimisation techniques. An MDO problem was formulated to design the wing planform of a typical turboprop and a turbofan passenger aircraft. The aircraft maximum take-off weight was selected as the objective function. A quasi-three-dimensional aerodynamic solver was developed to calculate the wing aerodynamic characteristics. Five various statistical methods and a quasi-analytical method are used to estimate the wing structural weight. These methods are compared to each other by analysing their accuracy and sensitivity to different design variables. The results of the optimisations showed that the optimum wing shape is affected by the method used to estimate the wing weight. Using different weight estimation methods also strongly affects the optimisation convergence history and computational time.

Information

Type
Research Article
Copyright
Copyright © Royal Aeronautical Society 2013