Hostname: page-component-7b7567c8c-8p88z Total loading time: 0 Render date: 2026-11-19T21:18:54.762Z Has data issue: false hasContentIssue false

A new analysis of fatigue under combined bending and twisting

Published online by Cambridge University Press:  04 July 2016

D. L. McDiarmid*
Affiliation:
The City University, London

Extract

Most service failures in fatigue start on a free surface, as in many cases the most severe stress conditions exist there and are of a bi-axial stress nature, such as a drive shaft under combined bending and twisting. This particular case of multi-axial stress fatigue, because of its importance in design, has seen considerable investigation, although several aspects of the stress situation complicate the analysis of the test results with regard to the development of a general criterion of fatigue failure under multi-axial stress. The principal stress axes rotate with variations in the ratio of bending to twisting and the shaft is subjected to a stress gradient. Only the extreme portions of the shaft in the plane of bending are under the maximum bending stress, whereas the complete surface of the shaft is subjected to the maximum torsion stress.

Information

Type
Technical notes
Copyright
Copyright © Royal Aeronautical Society 1974 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable