Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-19T02:33:55.556Z Has data issue: false hasContentIssue false

A Note on the Effect of Surface Finish on the Thrust of a Supersonic Conical Nozzle

Published online by Cambridge University Press:  04 July 2016

P. N. Rowe*
Affiliation:
(Formerly High Speed Fluid Kinetics Laboratory, Department of Chemical Engineering, Imperial College, now Chemical Engineering Division, A.E.R.E., Harwell.)

Extract

The Propelling Nozzles tested are turned from brass and the interior surface finish shows a centre line average of about 15 micro inches when examined on a Taylor Hobson machine. This is fairly rough compared with the estimated boundary layer thickness and it was required to know whether this in fact affected the thrust. The thrust of a nozzle manufactured by the usual process was measured before and after a polishing process. An improvement of one half per cent was recorded.

Information

Type
Technical Notes
Copyright
Copyright © Royal Aeronautical Society 1958

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable