Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-17T14:11:09.478Z Has data issue: false hasContentIssue false

A numerical study of hypersonic laminar film cooling

Published online by Cambridge University Press:  04 July 2016

X. Yang
Affiliation:
Department of Aerospace Engineering, University of Glasgow, UK
K. J. Badcock
Affiliation:
Department of Aerospace Engineering, University of Glasgow, UK
B. E. Richards
Affiliation:
Department of Aerospace Engineering, University of Glasgow, UK

Abstract

A computational study has been performed to investigate the effectiveness of film cooling in hypersonic laminar flows. Both the primary and the coolant flow are air. First, three different primary flow conditions are used for validation. A uniform boundary condition at the slot exit is found to give unrealistic predictions of the heat transfer rate, whilst a boundary condition involving extended coolant inlet gives improvement. Then five coolant injection rates and three slot heights are examined. It is confirmed that increasing the coolant injection rate can increase the film cooling effectiveness for laminar cases. But slot height does not play an important role under the flow conditions in this study. The computational results are compared with the experimental results and good agreement is achieved.

Information

Type
Research Article
Copyright
Copyright © Royal Aeronautical Society 2003 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable