Hostname: page-component-7b7567c8c-7pwfn Total loading time: 0 Render date: 2026-11-17T14:12:53.901Z Has data issue: false hasContentIssue false

On the Axisymmetrical Stress Concentration at an Eccentrically Reinforced Circular Hole in a Plate

Published online by Cambridge University Press:  07 June 2016

W. H. Wittrick*
Affiliation:
Department of Aeronautical Engineering, University of Sydney *
Get access

Summary

This paper is concerned with the effectiveness of reinforcing a hole in a plate on one surface only. The particular problem considered is that of a circular hole in a plate of infinite extent, subjected to axially symmetrical tension at infinity, when the reinforcement consists of an annular plate on one surface. Because of the interaction between bending and stretching, the problem is highly non-linear and it has only been possible to solve it for certain limiting cases. The stress concentration factor depends on a dimensionless parameter proportional to the tension at infinity. It is shown that the stress concentration factor is increased, because of the eccentricity of the reinforcement, if the parameter is small, but for values of the parameter greater than a certain minimum the stress concentration factor is decreased. The results also make it quite clear that there is no possibility of obtaining reasonably accurate results by linearisation of the equations.

Information

Type
Research Article
Copyright
Copyright © Royal Aeronautical Society. 1965

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable