Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-17T04:31:49.561Z Has data issue: false hasContentIssue false

Photoelastic Investigation on Plates with Single Interference-Fit Pins with Load Applied to Plate Only

Published online by Cambridge University Press:  07 June 2016

H. T. Jessop
Affiliation:
Department of Civil and Municipal Engineering, University College, London
C. Snell
Affiliation:
Department of Civil and Municipal Engineering, University College, London
G. S. Holister
Affiliation:
Department of Civil and Municipal Engineering, University College, London
Get access

Summary

The introduction of an interference-fit pin in a circular hole in a flat plate is found to result in a reduction in the stress concentration factor at the hole boundary under tension applied to the plate. The S.C.F. decreases rapidly with increase in the ratio of interference stress to applied tension, and decreases also with increase in the ratio of hole diameter to width of plate. Very little difference in the S.C.F. is found for different ratios of Young's modulus of pin and plate.

Information

Type
Research Article
Copyright
Copyright © Royal Aeronautical Society. 1956

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable