Hostname: page-component-7b7567c8c-tnkh4 Total loading time: 0 Render date: 2026-11-17T02:45:16.616Z Has data issue: false hasContentIssue false

Surface properties of bentonite and illite complexes with humus acids

Published online by Cambridge University Press:  09 July 2018

A. Księżopolska*
Affiliation:
Institute of Agrophysics, Polish Academy of Sciences, Doświadczalna 4, 20-290 Lublin 27, Poland
M. Pazur
Affiliation:
Institute of Agrophysics, Polish Academy of Sciences, Doświadczalna 4, 20-290 Lublin 27, Poland

Abstract

In this study, the reaction between humus acids (humic acid and β-humus fulvic acid fraction) and bentonite and illite was studied at a variety of pH values. The degree of reaction was determined from the specific surface area and molar energy of adsorption. Characteristic parameters of adsorption isotherms for the formation of a mono-layer of the adsorbent, such as the constant C from the BET equation, mono-layer capacity (N m), and standard error square (R 2), were also included in the study. After the addition of humus acids, the specific surface area of illite and bentonite decreased at all pH values, reaching a minimum at pH 4. This indicates different degrees of reaction of humus acids with the clays and, probably, partial hydrophobization of the materials. The degree of reaction of humus acids with the minerals depended on the pH and, for certain combinations, it was highest at pH 4. This value is relatively close to that at which the humus acid fractions in question precipitate from solution.

Information

Type
Research Papers
Copyright
Copyright © The Mineralogical Society of Great Britain and Ireland 2011

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable