Hostname: page-component-7b7567c8c-2jgqx Total loading time: 0 Render date: 2026-11-19T14:26:53.903Z Has data issue: false hasContentIssue false

Predicting the properties of bentonite-sand mixtures

Published online by Cambridge University Press:  09 July 2018

L. H. Mollins
Affiliation:
Department of Civil Engineering, University of Leeds, Leeds, LS2 9JT, UK
D. I. Stewart
Affiliation:
Department of Civil Engineering, University of Leeds, Leeds, LS2 9JT, UK
T. W. Cousens
Affiliation:
Department of Civil Engineering, University of Leeds, Leeds, LS2 9JT, UK

Abstract

One-dimensional swelling tests and hydraulic conductivity tests have been performed at vertical effective stresses up to 450 kPa on Na-bentonite powder and compacted sand/Na-bentonite mixtures (5, 10 and 20% bentonite by weight) to investigate the use of bentonite-improved soils for waste containment. It was found that bentonite powder swells to reach a final state described by a single straight line on a plot of void ratio against the logarithm of vertical effective stress, regardless of preparation technique. Swelling of sand/bentonite mixtures expressed in terms of the clay void ratio show a deviation from bentonite behaviour above a stress which depends on the bentonite content. Hydraulic conductivity data for bentonite and sand/bentonite mixtures indicate an approximately linear relationship between logarithm of hydraulic conductivity and logarithm of void ratio. A design model based on the clay void ratio, and the sand porosity and tortuosity is presented enabling the hydraulic conductivity of a mixture to be estimated.

Information

Type
Research Article
Copyright
Copyright © The Mineralogical Society of Great Britain and Ireland 1996

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable