Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-17T13:07:44.251Z Has data issue: false hasContentIssue false

Technological behaviour of some Tunisian clays prepared by dry ceramic processing

Published online by Cambridge University Press:  09 July 2018

K. Jeridi
Affiliation:
Laboratoire de Géoressources, CERTE BP 273, 8020 Soliman, Tunisia
M. Hachani
Affiliation:
Laboratoire de Géoressources, CERTE BP 273, 8020 Soliman, Tunisia
W. Hajjaji
Affiliation:
Laboratoire de Géoressources, CERTE BP 273, 8020 Soliman, Tunisia
B. Moussi
Affiliation:
Laboratoire de Géoressources, CERTE BP 273, 8020 Soliman, Tunisia
M. Medhioub
Affiliation:
Faculté des Sciences de Sfax, 3018, Sfax, Tunisia
A. López-Galindo*
Affiliation:
Instituto Andaluz de Ciencias de la Tierra. CSIC - Univ. Granada. Avda. Fuentenueva, s/n. 18002-Granada, Spain
F. Kooli
Affiliation:
ICES, 1 Pesek Road, Jurong Island 62 7833, Singapore
F. Zargouni
Affiliation:
Département de Géologie, Faculté des Sciences de Tunis, Université de Tunis El Manar, Tunisia
J. Labrincha
Affiliation:
Ceramics and Glass Engineering Dept & CICECO, University of Aveiro, 3810-193 Aveiro, Portugal
F. Jamoussi
Affiliation:
Laboratoire de Géoressources, CERTE BP 273, 8020 Soliman, Tunisia
*
*E-mail: alberto@ugr.es

Abstract

Lower Cretaceous (AJO and AJR) and Oligocene clays (AS) from northern Tunisia were analysed to evaluate their possible use in the production of earthenware tiles by dry processing and fast double-firing. The Cretaceous clays are carbonate-rich (AJO = 20%, AJR = 12%) while the Oligocene ones are carbonate-free. This led to noticeable differences in firing behaviour (shrinkage, sintering rate and loss on ignition) and consequently in functional properties (water absorption, mechanical strength, porosity). The AJO firing shrinkage is very small, which makes this clay suitable for rapid firing. The clays are illite-kaolinite-rich but the AS sample is mostly smectitic (44%) and so is used (10 wt.% maximum) only to adjust the consistency of the powder during pressing. The average agglomerate size ranges from 100 to 350 μm and the distribution is suitable for easy pressing of powders without any special need for further adjustments. Characterization of fired products confirms the high potential of these clays since all properties fall within the ceramic International Standards (ISO). For both technical and economic reasons dry processing is recommended for production of earthenware tiles, in particular for countries in sunnier climates, where solar energy can be exploited for clay drying.

Information

Type
Research Article
Copyright
Copyright © The Mineralogical Society of Great Britain and Ireland 2008

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable