Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-18T06:15:23.599Z Has data issue: false hasContentIssue false

Mercury Adsorption by Sulfurized Fibrous Silicates

Published online by Cambridge University Press:  02 April 2024

L. Daza
Affiliation:
Instituto de Catálisis y Petroleoquímica, C.S.I.C. Serrano 119, 28006 Madrid, Spain
S. Mendioroz
Affiliation:
Instituto de Catálisis y Petroleoquímica, C.S.I.C. Serrano 119, 28006 Madrid, Spain
J. A. Pajares
Affiliation:
Instituto del Carbón, C.S.I.C., La Corredoria, s/n. Oviedo, Spain
Rights & Permissions [Opens in a new window]

Abstract

Core share and HTML view are not available for this content. However, as you have access to this content, a full PDF is available via the 'Save PDF' action button.

To eliminate mercury vapor from gas streams, three major methods are used: condensation, absorption, and adsorption. This work deals with adsorption, using elemental sulfur as an active phase supported on sepiolite and palygorskite fibrous clays. Sulfur loads of 5–30% were deposited by catalytic oxidation of hydrogen sulfide at temperatures of <200°C, the clays acting first as a catalyst of the reaction and then as a carrier of the obtained sulfur. The ability of the sulfurized clay adsorbents to retain mercury was studied at 45°C and 1 mm Hg pressure. The high values found, about 4 g Hg/g S supported on clays, compared with 1.69 g Hg/g S on activated carbon under the same conditions are related to a more appropriate pore size distribution, with more of the pore widths >6 nm for the sulfurized silicates. Also, the allotropic state of the deposited sulfur, where Sπ (octo-catena) is better than Sλ (octo-cycle), may also be a contributing factor.

Information

Type
Research Article
Copyright
Copyright © 1991, The Clay Minerals Society