Hostname: page-component-7b7567c8c-8tzhz Total loading time: 0 Render date: 2026-11-19T12:08:07.630Z Has data issue: false hasContentIssue false

The design of a double ended interferometer(DEI)

Published online by Cambridge University Press:  02 December 2014

O. Kruger*
Affiliation:
NMISA, Private Bag X34, Lynwood Ridge 0040, Pretoria, South Africa
F. Hungwe
Affiliation:
NMISA, Private Bag X34, Lynwood Ridge 0040, Pretoria, South Africa
N. Farid
Affiliation:
NIS, Tersa st., Haram, Giza code 12211, P.O.136, Giza, Egypt
K. Schreve
Affiliation:
SUN, Private Bag X1 Matieland 7602, South Africa
*
⋆ Correspondence:oakruger@nmisa.org

Abstract

Core share and HTML view are not available for this content. However, as you have access to this content, a full PDF is available via the 'Save PDF' action button.

At NMISA the SI unit for length is realised by an iodine stabilised He-Ne laser, anoptical measurement. In industry most measurements are performed by mechanical probing.Gauge blocks are the link between the optical measurements and the mechanicalmeasurements, and are therefore critical in disseminating traceability. The gauge blocklength is currently determined by wringing the gauge block onto a platen. This islaborious, requires skill and causes contact errors. Since around 1943, there have beenefforts to build a double ended interferometer where gauge block length can be determinedwithout wringing it onto a platen. While there has been a lot of progress in buildingDEIs, to date, there is still no commercially available DEI. We present a collaborationproject between the National Metrology Institute of South Africa (NMISA), the NationalInstitute of Standards (NIS Egypt) and Stellenbosch University (SUN) in South Africa tobuild a double ended interferometer for use at the respective National MetrologyInstitutes. We investigate improvements to the interferometric calibration of gauge blocksand recent developments. The different systems currently in use in the national metrologylaboratories are described and various designs are investigated. Lastly the expectedoutcome of the project will be discussed.