Hostname: page-component-7b7567c8c-tnkh4 Total loading time: 0 Render date: 2026-11-17T03:59:55.227Z Has data issue: false hasContentIssue false

Digitally assisted equalization of third-order intermodulation products in wideband direct conversion receivers

Published online by Cambridge University Press:  22 June 2009

Edward A. Keehr
Affiliation:
Department of Electrical Engineering, California Institute of Technology, 1200 E. California Boulevard, M/C 136-93, Pasadena, CA 91125, USA.
Ali Hajimiri*
Affiliation:
Department of Electrical Engineering, California Institute of Technology, 1200 E. California Boulevard, M/C 136-93, Pasadena, CA 91125, USA.
*
Corresponding author: A. Hajimiri Email: hajimiri@caltech.edu
Rights & Permissions [Opens in a new window]

Abstract

An effective linearization technique capable of equalizing IM3 products resulting from an arbitrary out-of-band blocking scenario in a wideband direct conversion receiver is presented. IM3 products are regenerated in the RF analog domain of a low-power mixed-signal feedforward path and are used to cancel analogous signal terms in the original receiver at digital baseband via adaptive equalization. The composite SAW-less receiver achieves an improvement in effective IIP3 from −7.1 to +5.3 dBm under worst-case UMTS Region 1 blocking when the feedforward path is active.

Information

Type
Original Article
Copyright
Copyright © Cambridge University Press and the European Microwave Association 2009
Figure 0

Fig. 1.IM3 equalization concept in this work.

Figure 1

Fig. 2.Experimental UMTS receiver architecture.

Figure 2

Fig. 3.IM3 term generator schematic.

Figure 3

Fig. 4.Multistage cubing: frequency domain considerations.

Figure 4

Fig. 5.Calculated worst-case undesired IM3 product magnitude relative to peak desired alternate path IM3 magnitude versus baseband frequency offset.

Figure 5

Fig. 6.Phase response of interstage circuitry in IM3 term generator.

Figure 6

Fig. 7.Enhanced NLMS adaptive equalizer block diagram.

Figure 7

Fig. 8.Measured modified two-tone performance of the receiver, swept over amplitude.

Figure 8

Fig. 9.Measured modified two-tone performance of the receiver, swept over LO frequency. At LNA input TX power is −26 dBm, CW power is −34 dBm.

Figure 9

Fig. 10.Measured convergence of the adaptive equalization algorithm.

Figure 10

Fig. 11.Measured sensitivity results of the receiver.

Figure 11

Fig. 12.Measured performance summary of receiver.

Figure 12

Fig. 13.RF CMOS front-end analog die.