Hostname: page-component-7b7567c8c-fvjsw Total loading time: 0 Render date: 2026-11-17T00:28:09.556Z Has data issue: false hasContentIssue false

High linearity lead-lag style envelope modulator for RF power amplifiers

Published online by Cambridge University Press:  01 April 2015

Gavin T. Watkins*
Affiliation:
Toshiba Research Europe Limited, 32 Queen Square, Bristol, BS1 4ND, UK. Phone: +44 117 906 0740
Konstantinos Mimis
Affiliation:
Toshiba Research Europe Limited, 32 Queen Square, Bristol, BS1 4ND, UK. Phone: +44 117 906 0740
*
Corresponding author: G. T. Watkins Email: Gavin.watkins@toshiba-trel.com
Rights & Permissions [Opens in a new window]

Abstract

A new split frequency envelope modulator for envelope tracking radio-frequency power amplifiers is proposed based on a lead-lag network. By mathematically deriving the transfer functions of the lead-lag modulator and the conventional split frequency type, the lead-lag is shown to have a significantly flatter phase response. The frequency response of the two modulators is verified by simulation, where the phase transient of the lead-lag is significantly less than the 360° of the conventional type. They are further simulated with a 3 MHz bandwidth 3GPP long-term evolution (LTE) signal and the lead-lag shown to reduce the modulator's normalized root-mean-square error (NRMSE) from −27.3 to −39.2 dB. A practical demonstrator was developed around an existing high-efficiency modulator architecture. To maintain system efficiency synthetic impedance was incorporated in the low-frequency switched mode power supply (SMPS) path. This was achieved with voltage and current feedback around the SMPS. The dynamic wideband signal response was investigated by applying a 3 MHz LTE envelope signal to the modulator and comparing the input and output signals. The measured NRMSE was improved from −27.5 to −30.0 dB by adopting the lead-lag structure and the dynamic frequency response verifies correct operation.

Information

Type
Research Paper
Copyright
Copyright © Cambridge University Press and the European Microwave Association 2015 
Figure 0

Fig. 1.Split frequency envelope tracking RF PA; RL is the equivalent drain impedance of the RF PA.

Figure 1

Fig. 2.(a) Lag-lead network and its frequency response (b), (c) lead-lag network and its frequency response (d), (e) capacitor lead-lag network, (f) gain compensated lead-lag network and its frequency response (g), (h) lead-lag-based modulator.

Figure 2

Fig. 3.Simulated small signal frequency response of modulators.

Figure 3

Fig. 4.Simulated transfer response of original and lead-lag modulators.

Figure 4

Fig. 5.Potential divider formed at SMPS output (a) and equivalent circuit using a synthetic impedance (b).

Figure 5

Fig. 6.Simplified schematic of SMPS, the components in the shaded area are equivalent to G4.

Figure 6

Fig. 7.Simplified schematic of hybrid amplifier (G3).

Figure 7

Fig. 8.Photograph of prototype modulator.

Figure 8

Fig. 9.SMPS frequency response with 5 and 10 Ω loads.

Figure 9

Fig. 10.SMPS output impedance derived from Fig. 9.

Figure 10

Fig. 11.Dynamic gain response of the modulators with 3 MHz bandwidth LTE signal.

Figure 11

Fig. 12.Dynamic phase response of the modulators with 3 MHz bandwidth LTE signal.

Figure 12

Fig. 13.Measured transfer response of modulators.

Figure 13

Table 1.Comparison of similar envelope modulators.