Hostname: page-component-7b7567c8c-fvjsw Total loading time: 0 Render date: 2026-11-17T14:29:31.168Z Has data issue: false hasContentIssue false

Phase noise performance stabilization of PLL system under dynamic vibration condition for airborne applications

Published online by Cambridge University Press:  30 July 2020

Vipin Kumar*
Affiliation:
Product Development and Innovation Center, Bharat Electronics Limited, Bangalore 560013, India
R. Sivakumar
Affiliation:
Product Development and Innovation Center, Bharat Electronics Limited, Bangalore 560013, India
C. S. Jayasheela
Affiliation:
Product Development and Innovation Center, Bharat Electronics Limited, Bangalore 560013, India
Mahadev Sarkar
Affiliation:
Product Development and Innovation Center, Bharat Electronics Limited, Bangalore 560013, India
Shailendra Singh
Affiliation:
Product Development and Innovation Center, Bharat Electronics Limited, Bangalore 560013, India
*
Author for correspondence: Vipin Kumar, E-mail: vipin.kumar@bel.co.in
Rights & Permissions [Opens in a new window]

Abstract

The purpose of this paper is to disclose improved crystal based frequency source system covering design techniques and experimental methodologies for the stabilization of phase noise performance of X-band phase-locked loop (PLL) at 10.6 GHz. Phase noise performance of PLL-based unit under test (UUT) is prone to disturbance occurred in random vibration profile frequency spectrum. UUT self-resonance plays vital role in occurrence of disturbance in random vibration profile. The stabilization of phase noise performance during dynamic (random) vibration condition is achieved by following methodologies, i.e. vibration-isolator compensation techniques, purification tactic for reference crystal of PLL, and spatial location analysis for finding out mounting position of reference crystal. Spatial analysis helps to filter out UUT self-resonance frequency from random vibration spectrum which leads to reduction of frequency resonance pickups during random vibration testing.

Information

Type
Radar
Copyright
Copyright © Cambridge University Press and the European Microwave Association 2020
Figure 0

Fig. 1.(a) Basic block diagram of PLL. (b) Block diagram for X-band frequency generation.

Figure 1

Fig. 2.Active loop filter PLL system.

Figure 2

Fig. 3.S-band PLL performance results.

Figure 3

Fig. 4.Random vibration spectrum.

Figure 4

Fig. 5.Phase noise of typical reference source.

Figure 5

Fig. 6.Axial acceleration-sensitivity of reference source.

Figure 6

Fig. 7.UUT resonance pickup.

Figure 7

Fig. 8.Reference source assembly with vibration isolators.

Figure 8

Fig. 9.PSD damping effect of mechanical stabilization.

Figure 9

Fig. 10.Halt condition of random vibration profile.

Figure 10

Fig. 11.Typical random vibration profile.

Figure 11

Fig. 12.(a) Ambient phase noise performance of reference signal. (b) Ambient phase noise performance of X-band signal.

Figure 12

Fig. 13.(a) Phase noise degradation of reference signal. (b) Phase noise degradation of X-band signal.

Figure 13

Fig. 14.(a) Inset X-axis phase noise performance of reference signal. (b) Inset X-axis phase noise performance of X-band signal.

Figure 14

Fig. 15.(a) Inset Y-axis phase noise performance of reference signal. (b) Inset Y-axis phase noise performance of X-band signal.

Figure 15

Fig. 16.(a) Inset Z-axis phase noise performance of reference signal. (b) Inset Z-axis phase noise performance of X-band signal.

Figure 16

Table 1.Reference source random vibration results

Figure 17

Table 2.X-band random vibration results