Hostname: page-component-7b7567c8c-tnkh4 Total loading time: 0 Render date: 2026-11-16T17:24:17.831Z Has data issue: false hasContentIssue false

Polarization-independent single-layer ultra-wideband frequency-selective surface

Published online by Cambridge University Press:  28 September 2015

Ramprabhu Sivasamy*
Affiliation:
Department of ECE, College of Engineering Guindy, Anna University, Chennai – 600025, India. Phone: +919943120420Department of ECE, SSN College of Engineering, Kalavakkam, Chennai – 603110, India
Balaji Moorthy
Affiliation:
Department of ECE, College of Engineering Guindy, Anna University, Chennai – 600025, India. Phone: +919943120420
Malathi Kanagasabai
Affiliation:
Department of ECE, College of Engineering Guindy, Anna University, Chennai – 600025, India. Phone: +919943120420
Jithila V. George
Affiliation:
Department of ECE, College of Engineering Guindy, Anna University, Chennai – 600025, India. Phone: +919943120420
Livya Lawrance
Affiliation:
Department of ECE, College of Engineering Guindy, Anna University, Chennai – 600025, India. Phone: +919943120420
Dinesh Babu Rajendran
Affiliation:
Department of ECE, College of Engineering Guindy, Anna University, Chennai – 600025, India. Phone: +919943120420
*
Corresponding author: R. Sivasamy Email: ramprabhuece@gmail.com
Rights & Permissions [Opens in a new window]

Abstract

An ultra-wideband (UWB) frequency-selective surface (FSS) exhibiting band rejection characteristic is presented in this paper. The proposed unit cell has the size of 14 × 14 mm2 which is approximately 0.18 × 0.18 λo, where λo corresponds to free space wavelength at the lower cut-off frequency. The proposed UWB FSS consists of a single-layer substrate and provides 20 dB attenuation level for a wide bandwidth of 7.53 GHz at the normal incidence. The proposed FSS is polarization independent and also provides angular-independent operation for the EM wave incidences of 15°, 30° and 45° with 11.5 dB attenuation over a wide range from 4 to 14 GHz.

Information

Type
Research Papers
Copyright
Copyright © Cambridge University Press and the European Microwave Association 2015 
Figure 0

Fig. 1.(a) Front view of the proposed unit cell. (b) Side view of the proposed FSS unit cell.

Figure 1

Table 1.Unit-cell design parameters.

Figure 2

Fig. 2.Evolution of unit cell (a) square loop, (b) modified offset crossed dipole, and (c) proposed unit cell.

Figure 3

Fig. 3.Transmission characteristics of the square loop, offset crossed dipole, and modified offset crossed dipole.

Figure 4

Fig. 4.Transmission characteristics of the proposed FSS.

Figure 5

Fig. 5.TE mode transmission characteristics.

Figure 6

Fig. 6.TM mode transmission characteristics.

Figure 7

Fig. 7.Transmission characteristics for various values of S1, S2, and S3.

Figure 8

Fig. 8.Transmission characteristics for various values of h and G.

Figure 9

Fig. 9.Fabricated prototype.

Figure 10

Fig. 10.Measurement setup.

Figure 11

Fig. 11.Comparison of simulated and measured transmission characteristics.