Hostname: page-component-7b7567c8c-slfcl Total loading time: 0 Render date: 2026-11-19T12:22:49.217Z Has data issue: false hasContentIssue false

Manipulation of turbulent boundary layers by outer-layer devices: skin-friction and flow-visualization results

Published online by Cambridge University Press:  21 April 2006

A. M. Savill
Affiliation:
Fluid Dynamics Section, Cavendish Laboratory, University of Cambridge, Madingley Road, Cambridge CB3 0HE, UKPresent address: Engineering Department, University of Cambridge, Trumpington Street, Cambridge CB2 1PZ, UK.
J. C. Mumford
Affiliation:
Fluid Dynamics Section, Cavendish Laboratory, University of Cambridge, Madingley Road, Cambridge CB3 0HE, UKPresent address: Engineering Department, University of Cambridge, Trumpington Street, Cambridge CB2 1PZ, UK.

Abstract

Parametric studies have been made of devices introduced into the outer region of a low-Reynolds-number turbulent boundary layer (Reθ = 1000-3500) with a view to understanding the manner in which such ‘manipulators’ reduce the surface drag. The devices considered were single flat plates, a cylinder with the same drag as one of these, and two plates stacked, staggered, and in tandem, with chord Reynolds numbers Rec in the range 1000-100000. Direct measurements of local skin friction using a floating-plate drag balance are reported together with the results of laser- sheet smoke flow visualization. The skin-friction results are in good agreement with other floating-element data while the visual and photographic studies in both stationary and convected frames completely support the hairpin description of the boundary-layer structure, and reveal that the wake of the device may play a more important role than has previously been suggested. A picture is presented of the interaction of the devices and their wakes with the hairpin eddy structure which could explain the magnitudes and shapes of the skin-friction distributions observed downstream; their dependence on the height, thickness, and if appropriate, length and spacing of the device(s); the optimum values for these parameters; and the existence of a preferred, tandem plate configuration. The results suggest that such plates do not act primarily as large-eddy break-up systems (LEBUs). Instead several ‘active’ mechanisms are identified which supplement the ‘passive’ effect of the imposed momentum defect. The suppression of large-scale motions is one of these, but, a t least for our relatively thick devices, it would appear that it is an interaction between the vortices, introduced into the layer via the wake, and the near-wall structure that provides the principal mechanism for reducing the skin friction. The observation that the maximum skin-friction reduction always occurred close to the position where these vortices reached the sublayer provides strong evidence for such a view.

Information

Type
Research Article
Copyright
© 1988 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable