Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-16T04:33:46.828Z Has data issue: false hasContentIssue false

On the generation and evolution of internal gravity waves

Published online by Cambridge University Press:  20 April 2006

Faiza S. Lansing
Affiliation:
Departments of Mechanical and Aerospace Engineering, University of Southern California, Los Angeles, California 90089-1453Present address: Tracking Systems and Applications Section, Jet Propulsion Laboratory, Pasadena, California 91109.
Tony Maxworthy
Affiliation:
Departments of Mechanical and Aerospace Engineering, University of Southern California, Los Angeles, California 90089-1453

Abstract

In order to study the tidal generation and evolution of internal waves, both experimentally and theoretically, a two-dimensional two-layer model has been developed. The laboratory model consists of two immiscible fluid layers in a long wave tank, where time-dependent flow can be created by towing a suitably shaped obstacle with a sinusoidal motion. The effects of changing the Froude number and the ratio of the depths of the two fluid layers on the shape of the interface are studied. The first theoretical model considers the motion to be quasi-steady, allowing only a balance between buoyancy and inertial forces, and is in reasonable agreement with the experimental results for very slow motions and the initial phase of the tidal cycle only. A more complete numerical solution is based on the vortex-point method in which the interface is modelled by a set of discrete vortices, while the rigid boundaries, which include the obstacle, are modelled by a source distribution. The resulting governing equations are expressed in Lagrangian form, and the baroclinic generation of vorticity is related to the generation of source density, through two simultaneous integrodifferential equations. For small Froude numbers, the experimental and numerical results are in good quantitative agreement. At large Froude numbers, the numerical solution, which does not consider mixing between the two layers nor boundary-layer separation from the obstacle, gives a slight difference in the position of the maximum interface displacement from that found in the experiment.

Information

Type
Research Article
Copyright
© 1984 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable