Hostname: page-component-7b7567c8c-8tzhz Total loading time: 0 Render date: 2026-11-19T21:07:12.943Z Has data issue: false hasContentIssue false

Collisional particle pressure measurements in solid–liquid flows

Published online by Cambridge University Press:  25 December 1997

R. ZENIT
Affiliation:
Division of Engineering and Applied Sciences, California Institute of Technology, Pasadena, CA 91125, USA
M. L. HUNT
Affiliation:
Division of Engineering and Applied Sciences, California Institute of Technology, Pasadena, CA 91125, USA
C. E. BRENNEN
Affiliation:
Division of Engineering and Applied Sciences, California Institute of Technology, Pasadena, CA 91125, USA
Rights & Permissions [Opens in a new window]

Abstract

Core share and HTML view are not available for this content. However, as you have access to this content, a full PDF is available via the 'Save PDF' action button.

Experiments were conducted to measure the collisional particle pressure in both cocurrent and countercurrent flows of liquid–solid mixtures. The collisional particle pressure, or granular pressure, is the additional pressure exerted on the containing walls of a particulate system due to the particle collisions. The present experiments involve both a liquid-fluidized bed using glass, plastic or steel spheres and a vertical gravity-driven flow using glass spheres. The particle pressure was measured using a high-frequency-response flush-mounted pressure transducer. Detailed recordings were made of many different particle collisions with the active face of this transducer. The solids fraction of the flowing mixtures was measured using an impedance volume fraction meter. Results show that the magnitude of the measured particle pressure increases from low concentrations (<10% solid volume fraction), reaches a maximum for intermediate values of solid fraction (30–40%), and decreases again for more concentrated mixtures (>40%). The measured collisional particle pressure appears to scale with the particle dynamic pressure based on the particle density and terminal velocity. Results were obtained and compared for a range of particle sizes, as well as for two different test section diameters.

In addition, a detailed analysis of the collisions was performed that included the probability density functions for the collision duration and collision impulse. Two distinct contributions to the collisional particle pressure were identified: one contribution from direct contact of particles with the pressure transducer, and the second one resulting from particle collisions in the bulk that are transmitted through the liquid to the pressure transducer.

Information

Type
Research Article
Copyright
© 1997 Cambridge University Press