Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-17T16:51:12.122Z Has data issue: false hasContentIssue false

Control of stationary cross-flow modes in a Mach 3.5 boundary layer using patterned passive and active roughness

Published online by Cambridge University Press:  08 February 2013

Chan Yong Schuele
Affiliation:
University of Notre Dame, Institute for Flow Physics and Control, Aerospace and Mechanical Engineering Department, Notre Dame, IN 46556, USA
Thomas C. Corke*
Affiliation:
University of Notre Dame, Institute for Flow Physics and Control, Aerospace and Mechanical Engineering Department, Notre Dame, IN 46556, USA
Eric Matlis
Affiliation:
University of Notre Dame, Institute for Flow Physics and Control, Aerospace and Mechanical Engineering Department, Notre Dame, IN 46556, USA
*
†Email address for correspondence: tcorke@nd.edu
Rights & Permissions [Opens in a new window]

Abstract

Core share and HTML view are not available for this content. However, as you have access to this content, a full PDF is available via the 'Save PDF' action button.

Spanwise-periodic roughness designed to excite selected wavelengths of stationary cross-flow modes was investigated in a three-dimensional boundary layer at Mach 3.5. The test model was a sharp-tipped $1{4}^{\circ } $ right-circular cone. The model and integrated sensor traversing system were placed in the Mach 3.5 supersonic low disturbance tunnel (SLDT) equipped with an axisymmetric ‘quiet design’ nozzle at NASA Langley Research Center. The model was oriented at a $4. {2}^{\circ } $ angle of attack to produce a mean cross-flow velocity component in the boundary layer over the cone. The research examined both passive and active surface roughness. The passive roughness consisted of indentations (dimples) that were evenly spaced around the cone at an axial location that was just upstream of the first linear stability neutral growth branch for cross-flow modes. The active roughness consisted of an azimuthal array of micrometre-sized plasma actuators that were designed to produce the effect of passive surface bumps. Two azimuthal mode numbers of the passive and active patterned roughness were examined. One had an azimuthal mode number that was in the band of initially amplified stationary cross-flow modes. This was intended to represent a controlled baseline condition. The other azimuthal mode number was designed to suppress the growth of the initially amplified stationary cross-flow modes and thereby increase the transition Reynolds number. The results showed that the stationary cross-flow modes were receptive to both the passive and active patterned roughness. Only the passive roughness was investigated at a unit Reynolds number where transition would occur on the cone. Transition front measurements using the Preston tube approach indicated that the transition Reynolds number had increased by 35 % with the subcritical wavenumber roughness compared with the baseline smooth tip cone, and by 40 % compared with the critical wavenumber roughness. Based on the similarities in the response of the stationary cross-flow modes with the active roughness, we expect it would produce a similar transition delay.

Information

Type
Papers
Copyright
©2013 Cambridge University Press