Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-17T14:53:50.579Z Has data issue: false hasContentIssue false

Deep-water sediment wave formation: linear stability analysis of coupled flow/bed interaction

Published online by Cambridge University Press:  18 May 2011

L. LESSHAFFT
Affiliation:
Laboratoire d'Hydrodynamique, CNRS – École Polytechnique, 91128 Palaiseau, FranceDepartment of Mechanical Engineering, University of California, Santa Barbara, CA 93106, USA
B. HALL
Affiliation:
Department of Mechanical Engineering, University of California, Santa Barbara, CA 93106, USA
E. MEIBURG*
Affiliation:
Department of Mechanical Engineering, University of California, Santa Barbara, CA 93106, USA
B. KNELLER
Affiliation:
Department of Geology and Petroleum Geology, University of Aberdeen, Aberdeen AB24 3FX, UK
*
†Email address for correspondence: meiburg@engineering.ucsb.edu
Rights & Permissions [Opens in a new window]

Abstract

Core share and HTML view are not available for this content. However, as you have access to this content, a full PDF is available via the 'Save PDF' action button.

A linear stability analysis is carried out for the interaction of an erodible sediment bed with a sediment-laden, stratified flow above the bed, such as a turbidity or bottom current. The fluid motion is described by the full, two-dimensional Navier–Stokes equations in the Boussinesq approximation, while erosion is modelled as a diffusive flux of particles from the bed into the fluid. The stability analysis shows the existence of both Tollmien–Schlichting and internal wave modes in the stratified boundary layer. For the internal wave mode, the stratified boundary layer acts as a wave duct, whose height can be determined analytically from the Brunt–Väisälä frequency criterion. Consistent with this criterion, distinct unstable perturbation wavenumber regimes exist for the internal wave mode, which are associated with different numbers of pressure extrema in the wall-normal direction. For representative turbidity current parameters, the analysis predicts unstable wavelengths that are consistent with field observations. As a key condition for instability to occur, the base flow velocity boundary layer needs to be thinner than the corresponding concentration boundary layer. For most of the unstable wavenumber ranges, the phase relations between the sediment bed deformation and the associated wall shear stress and concentration perturbations are such that the sediment waves migrate in the upstream direction, which again is consistent with field observations.

Information

Type
Papers
Copyright
Copyright © Cambridge University Press 2011