Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-16T14:43:03.062Z Has data issue: false hasContentIssue false

Modelling a hydrodynamic instability in freely settling colloidal gels

Published online by Cambridge University Press:  12 October 2018

Zsigmond Varga
Affiliation:
Department of Chemical Engineering, Massachusetts Institute of Technology, Cambridge, MA 02139, USA
Jennifer L. Hofmann
Affiliation:
Department of Chemical Engineering, Massachusetts Institute of Technology, Cambridge, MA 02139, USA
James W. Swan*
Affiliation:
Department of Chemical Engineering, Massachusetts Institute of Technology, Cambridge, MA 02139, USA
*
†Email address for correspondence: jswan@mit.edu

Abstract

Attractive colloidal dispersions, suspensions of fine particles which aggregate and frequently form a space-spanning elastic gel are ubiquitous materials in society with a wide range of applications. The colloidal networks in these materials can exist in a mode of free settling when the network weight exceeds its compressive yield stress. An equivalent state occurs when the network is held fixed in place and used as a filter through which the suspending fluid is pumped. In either scenario, hydrodynamic instabilities leading to loss of network integrity occur. Experimental observations have shown that the loss of integrity is associated with the formation of eroded channels, so-called streamers, through which the fluid flows rapidly. However, the dynamics of growth and subsequent mechanism of collapse remain poorly understood. Here, a phenomenological model is presented that describes dynamically the radial growth of a streamer due to erosion of the network by rapid fluid back flow. The model exhibits a finite-time blowup – the onset of catastrophic failure in the gel – due to activated breaking of the inter-colloid bonds. Brownian dynamics simulations of hydrodynamically interacting and settling colloids in dilute gels are employed to examine the initiation and propagation of this instability, which are in good agreement with the theory. The model dynamics is also shown to accurately replicate measurements of streamer growth in two different experimental systems. The predictive capabilities and future improvements of the model are discussed and a stability-state diagram is presented providing insight into engineering strategies for avoiding settling instabilities in networks meant to have long shelf lives.

Information

Type
JFM Papers
Copyright
© 2018 Cambridge University Press 
Figure 0

Figure 1.The micromechanical model considers a particle gel network freely settling in a gravitational field $\boldsymbol{g}$. (a) As the particles move downward, to conserve mass, fluid will flow upward through the pores (black arrows). (b) Due to local density fluctuations the fluid will find a path of least resistance, where increased back flow will nucleate a streamer that spans the network. (c) As the back flow increases, the fluid exerts drag on the particles at the interface leading to an activated rate of erosion and growth of the streamer. (d) The streamer is modelled as a cylindrical channel with evolving radius $R$ in a gel of size $L$. The growth rate will depend on the relative magnitude of particle fluxes away from ($j_{in}$) and into the network ($j_{out}$).

Figure 1

Table 1.The five network parameters characterizing the scenario of a freely settling colloidal gel considered in the model.

Figure 2

Figure 2.In simulations we observe freely sedimenting gels in a gravitational field $\boldsymbol{g}$ and study the effects of fluid back flow over time (see § 3.1 for simulation details). These are snapshots of a simulation with $\unicode[STIX]{x1D6FF}=0.1$, $\unicode[STIX]{x1D716}=0.05$, $G=0.5$ and $\unicode[STIX]{x1D719}=20\,\%$ (see also supplementary movies of the collapse). The differently coloured layers are purely for illustrative purposes, indicate initial particle positions in the gel, and are meant to guide the eye through the breakdown of the network during free settling shown for a particle depth of $30a$. The dispersion gelled over $500\unicode[STIX]{x1D70F}_{D}$ in the absence of gravity and has a structure characterized by $d_{f}=2.05$. (a) At $t=0\unicode[STIX]{x1D70F}_{D}$ gravity is turned on in the simulation and the network begins to settle. (b) After initial uniform settling, a single cylindrical streamer nucleates (bottom centre). (c) The streamer is both growing radially and its height spans the bottom half of the network. (d) At the onset of settling rate increase ($t=t_{crossover}$) the streamer spans the height of the gel. (e) The streamer continues to grow radially, filling the entire sample, destabilizing and changing the uniform settling of the network. (f) There is complete loss of network integrity as entire aggregates are ripped off the gel.

Figure 3

Figure 3.The average network settling rate $U(t)$ normalized by the initial rate $U(0)$ as a function of simulation time in units of the characteristic single-particle settling time $\unicode[STIX]{x1D70F}_{G}$ for increasing $G$ with $\unicode[STIX]{x1D6FF}=0.1$, $\unicode[STIX]{x1D716}=0.05$ and $\unicode[STIX]{x1D719}=20\,\%$. The onset of rapid growth in settling rate, $t_{crossover}$, is the point in time where the power-law growth at a given $G$ intersects the plateau of uniform settling $U(t)=U(0)$, marked by the two dashed lines.

Figure 4

Figure 4.There is a direct correlation between the increase in streamer volume and the accelerating settling network, which supports the model’s premise that streamer nucleation and growth are causes for loss of network integrity in settling gels. (a) The growth of streamer volume normalized on the simulation box volume plotted as a function of simulation time for increasing $G$ with $\unicode[STIX]{x1D6FF}=0.1$, $\unicode[STIX]{x1D716}=0.05$ and $\unicode[STIX]{x1D719}=20\,\%$. (b) The onset of rapid growth in streamer volume $t_{crossover}^{volume}$ plotted versus the onset of power-law growth in network settling velocity, $t_{crossover}$.

Figure 5

Figure 5.The onset of rapid network collapse, $t_{crossover}$ as measured in dynamic simulations is plotted individually as a function of the network parameters $G$, $\unicode[STIX]{x1D719}$, $\unicode[STIX]{x1D6FF}$ and $\unicode[STIX]{x1D716}$ respectively, while all others are held constant. The collapse dynamics exhibit the power-law behaviour predicted by the micromechanical model for networks with $d_{f}\approx 2$. Each data point is the average of three independent simulations and error bars represent 95 % confidence intervals. The slope of the best-fit line in (d) yields the scaling coefficient $d_{3}$ that sets the relevant strength of attraction, $d_{3}\approx 5.6$.

Figure 6

Figure 6.The onset of rapid network collapse, $t_{crossover}$ as measured in dynamic simulations is plotted as a function of the model prediction $t_{blowup}$, computed for the combination of $\unicode[STIX]{x1D6FF}$, $\unicode[STIX]{x1D716}$, $G$, $\unicode[STIX]{x1D719}$ and $d_{f}$ used in the respective simulation run. Each data point is the average of three independent simulations with the same unique combination of parameters in the parameter space and error bars represent 95 % confidence intervals. The model predicts the collapse dynamics to within a scalar coefficient. A linear best fit through the data (dashed line) is employed to identify the coefficient.

Figure 7

Figure 7.The measured values of $t_{crossover}$ in the presence of a seeded hole at $t=0$ relative to the time scale of an unperturbed sample are plotted as a function of the relative seeded channel radius $R_{0}/R^{\ast }$ for different $\unicode[STIX]{x1D719}$. $R^{\ast }$ is set by a combination of $\unicode[STIX]{x1D6FF}$, $\unicode[STIX]{x1D716}$ and $G$. Each data point is the average of three independent simulations with the same unique combination of parameters in the parameter space and error bars represent 95 % confidence intervals. The measured values are in good agreement with the model prediction of (3.3) using a value of $d_{f}=2$ (dashed line).

Figure 8

Table 2.Experimental parameters of collapsing gels as found in Starrs et al. (2002) and Secchi et al. (2014).

Figure 9

Figure 8.Time evolution of streamer radius $R$ as extracted from experimental data published in the literature and the best-fit predictions of our model. (a) Comparison of data published by Starrs et al. (2002) (open squares) and the best-fit prediction of the model (dashed line). (b) Comparison of data published by Secchi et al. (2014) (open circles) and the best-fit prediction of the model (dashed line).

Figure 10

Table 3.Values of $t_{blowup}$ and $R^{\ast }$ as found from the model best fit to the experimental data and their estimates based on details of the experimental parameters in table 2. In the case of Secchi et al. (2014) estimates are based on the primary particle radius and three times the size for $a$.

Figure 11

Figure 9.Parity plot of the predicted and the measured distance to blowup (see text for details) for the two very different experimental systems. The theory is able to capture the underlying collapse dynamics well, independent of the experimental details.

Figure 12

Figure 10.The stability-state diagram marks the continuous region of stability (shaded) and distinguishes it from catastrophic instability beyond (here only a three-dimensional cross-section of the entire parameter space is shown). In the stable region $t_{blowup}$ is larger than the desired $t_{shelf\,life}$ of a given product.

Varga et al. supplementary movie 1

Movie of settling gel with δ=0.1, ε=0.05, G=0.5 and φ=20% (same as in figure 2). The differently coloured layers are purely for illustrative purposes, indicate initial particle positions in the gel, and are meant to guide the eye through the breakdown of the network during free settling. The dispersion gelled over 500τ_D in the absence of gravity and has a structure characterized by d_f=2.05. At t=0τ_G gravity is turned on in the simulation and the network settles for 2500 τ_G.

Download Varga et al. supplementary movie 1(Video)
Video 13 MB

Varga et al. supplementary movie 2

Movie of settling gel with δ=0.15, ε=0.05, G=0.3 and φ=20%. The differently coloured layers are purely for illustrative purposes, indicate initial particle positions in the gel, and are meant to guide the eye through the breakdown of the network during free settling. The dispersion gelled over 500τ_D in the absence of gravity and has a structure characterized by d_f=2.11. At t=0τ_G gravity is turned on in the simulation and the network settles for 2500 τ_G.

Download Varga et al. supplementary movie 2(Video)
Video 16.3 MB

Varga et al. supplementary movie 3

Movie of settling gel with δ=0.1, ε=0.02, G=0.5 and φ=20%. The differently coloured layers are purely for illustrative purposes, indicate initial particle positions in the gel, and are meant to guide the eye through the breakdown of the network during free settling. The dispersion gelled over 500τ_D in the absence of gravity and has a structure characterized by d_f=1.96. At t=0τ_G gravity is turned on in the simulation and the network settles for 2500 τ_G.

Download Varga et al. supplementary movie 3(Video)
Video 16.4 MB

Varga et al. supplementary movie 4

Movie of settling gel with δ=0.1, ε=0.05, G=0.5 and φ=20%. The differently coloured layers are purely for illustrative purposes, indicate initial particle positions in the gel, and are meant to guide the eye through the breakdown of the network during free settling. The dispersion gelled over 500τ_D in the absence of gravity and has a structure characterized by d_f=2.08. A streamer was seeded in the centre with a radius of R_0=0.8R^* and the gel cross section is shown. At t=0τ_G gravity is turned on in the simulation and the network settles for 2500 τ_G.

Download Varga et al. supplementary movie 4(Video)
Video 9.5 MB