Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-17T07:06:50.925Z Has data issue: false hasContentIssue false

Multiple-timescale analysis of Taylor dispersion in converging and diverging flows

Published online by Cambridge University Press:  26 April 2006

Michelle D. Bryden
Affiliation:
Department of Chemical Engineering, Massachusetts Institute of Technology, Cambridge, MA 02139–4307, USA
Howard Brenner
Affiliation:
Department of Chemical Engineering, Massachusetts Institute of Technology, Cambridge, MA 02139–4307, USA

Abstract

A multiple-timescale analysis is employed to analyse Taylor-dispersion-like convective-diffusive processes in converging and diverging flows. A long-time asymptotic equation governing the cross-sectionally averaged solute probability density is derived. The form of this equation is shown to be dependent upon the number of spatial dimensions characterizing the duct or ‘cone’. The two-dimensional case (non-parallel plates) is shown to be fundamentally different from that for three dimensions (circular cone) in that, in two dimensions, a Taylor dispersion description of the process is possible only for small Peclet numbers or angles of divergence. In contrast, in three dimensions, a Taylor dispersion description is always possible provided sufficient time has passed since the initial introduction of solute into the system. The convective Taylor dispersion coefficients $\overline{D}_c$ for the respective cases of low-Reynolds-number flow between non-parallel plates and in a circular cone are computed and their limiting values, $\overline{D}_c^0$, for zero apex angle are shown to be consistent with the known results for Taylor dispersion between parallel plates and in a circular cylinder. When plotted in the non-dimensional form of $\overline{D}_c/\overline{D}^0_c$ versus the half-vertex angle θ0, the respective dispersivity results for the two cases hardly differ from one another, increasing monotonically from 1.0 for θ0 = 0 to approximately 2.6 for a fully flared duct, θ0 = θ/2. Lastly, the techniques developed above for the case of rectilinear channel and duct boundaries are extended to the case of curvilinear boundaries, and an illustrative calculation performed for the case of axisymmetric flow in a flared Venturi tube.

Information

Type
Research Article
Copyright
© 1996 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable