Hostname: page-component-7b7567c8c-7pwfn Total loading time: 0 Render date: 2026-11-17T12:42:07.430Z Has data issue: false hasContentIssue false

Numerical predictions for laminar source-sink flow in a rotating cylindrical cavity

Published online by Cambridge University Press:  20 April 2006

J. W. Chew
Affiliation:
School of Engineering and Applied Sciences, University of Sussex, Falmer, Brighton, EnglandPresent address: Theoretical Science Group, Rolls-Royce Limited, P.O. Box 31, Derby, England.
J. M. Owen
Affiliation:
School of Engineering and Applied Sciences, University of Sussex, Falmer, Brighton, England
J. R. Pincombe
Affiliation:
School of Engineering and Applied Sciences, University of Sussex, Falmer, Brighton, England

Abstract

Numerical solutions are presented for steady, axisymmetric, laminar, isothermal, source–sink flow in a rotating cylindrical cavity. These results, which are in good agreement with previously published experimental work, have been used to give a fresh insight into the nature of the flow and to investigate the validity of other theoretical solutions. When the fluid enters the cavity through a central uniform radial source and leaves through an outer sink, it is shown that the flow near the disks can be approximated by two known analytical solutions. If the radial source is replaced by an axial inlet the flow becomes more complex, with a wall jet forming on the downstream disk at sufficiently high flow rates.

Information

Type
Research Article
Copyright
© 1984 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable