Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-18T07:36:11.230Z Has data issue: false hasContentIssue false

On the stability of laminar boundary-layer flow over a flat plate with a compliant surface

Published online by Cambridge University Press:  21 April 2006

P. K. Sen
Affiliation:
Department of Applied Mechanics, Indian Institute of Technology, New Delhi 110016, India
D. S. Arora
Affiliation:
Department of Applied Mechanics, Indian Institute of Technology, New Delhi 110016, India

Abstract

The problem has been examined using a kinematic model for wall pliability, wherein a kinematic postulation of the wall boundary conditions is made. A form of the normalized wall-displacement and its phase are used as additional parameters in an extended eigenvalue problem. Using this technique the entire gamut of possibilities regarding stability of flow past (normally) pliable walls can be examined, yet without recourse to any specific material properties for the wall. Rather, the results based on the kinematic model can be used to back-calculate the material properties corresponding to any chosen model for the dynamics of the wall. A sample back calculation is discussed herein for the Benjamin–Landahl wall model, and based on this some predictions are made regarding both stabilization of the flow and physical realizability of modes. It is believed that the kinematic model will prove useful in further understanding of the problem, and in the design of stabilizing coatings.

The results show that there are three important ‘mode classes’ (distinct from ‘modes’), namely the Tollmien–Schlichting (TS), resonant (R) and Kelvin–Helmholtz (KH). Whereas the TS and R mode classes broadly agree with modes bearing similar names as found by earlier workers, the present KH mode class is difficult to classify based on earlier work. Moreover, there are also important transitional mode classes in the regions of bifurcations of the regular mode classes.

Two important concepts evolve in connection with the TS and R mode classes, namely the existence of ‘stable pockets’ for the former and ‘unstable pockets’ for the latter. It is also confirmed herein that there are conflicting requirements on the damping d to stabilize TS and R modes. Considering these points it has been suggested that TS and R modes be avoided by keeping soft surfaces as compliant coatings. However, this in turn leads to instabilities from one of the transitional mode classes. It is also seen that a soft surface that is also marginally active (i.e. having a small negative value of d) could render even better stabilization.

Information

Type
Research Article
Copyright
© 1988 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable

Supplementary material: PDF

Sen and Arora supplementary material

Supplementary Material

Download Sen and Arora supplementary material(PDF)
PDF 1.2 MB