Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-17T11:20:11.690Z Has data issue: false hasContentIssue false

Some effects of inclination on elastohydrodynamic squeeze film problems

Published online by Cambridge University Press:  11 April 2006

D. Whicker
Affiliation:
Engineering Mechanics Department, Research Laboratories, General Motors Corporation, Warren, Michigan 48090
A. L. Browne
Affiliation:
Engineering Mechanics Department, Research Laboratories, General Motors Corporation, Warren, Michigan 48090
S. M. Rohde
Affiliation:
Engineering Mechanics Department, Research Laboratories, General Motors Corporation, Warren, Michigan 48090

Abstract

An analysis is presented for the non-inertial descent of an inclined sinkage element (a rectangular prism) through a viscous fluid onto a rigid surface. The effects of sinkage-element deformability, slip velocity and time-dependent loading conditions are considered. Unlike previous analyses no assumptions are made a priori about the form of the pressure distribution during, or the effect of corners on, inclined sinkage. The results for rigid square plates are compared with those of previous analyses and with the limited amount of experimental data available. Results are also presented for a deformable sinkage element, which is used to model the action of an individual tyre tread element on a wet pavement. An inclination function based on available data on the tyre surface shape in the footprint region is used. The loading function for this case is based on measured values of tyre footprint pressure.

Information

Type
Research Article
Copyright
© 1976 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable