Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-18T21:59:07.877Z Has data issue: false hasContentIssue false

Surface-wave damping in a circular cylinder with a fixed contact line

Published online by Cambridge University Press:  26 April 2006

D. M. Henderson
Affiliation:
Department of Mathematics, Pennsylvania State University, University Park, PA 16802, USA
J. W. Miles
Affiliation:
Institute of Geophysics and Planetary Physics, University of California, San Diego, La Jolla, CA 92093–0225, USA

Abstract

The natural frequencies and damping ratios for surface waves in a circular cylinder are calculated on the assumptions of a fixed contact line, Stokes boundary layers, and either a clean or a fully contaminated surface. These theoretical predictions are compared with the measurements for the first six modes in a brimfull, sharp-edged cylinder of radius 2.77 cm and depth 3.80 cm. The differences between the predicted and observed frequencies were less than 0.5% for all but the fundamental axisymmetric mode with a clean surface. The difference between the predicted and observed damping ratio for the dominant mode with a clean surface was 20%; this difference was significantly larger for the higher modes with a clean surface and for all of the modes with a contaminated surface.

Information

Type
Research Article
Copyright
© 1994 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable