Hostname: page-component-7b7567c8c-slfcl Total loading time: 0 Render date: 2026-11-19T19:05:03.434Z Has data issue: false hasContentIssue false

Turbulent flow with heat transfer in plane and curved wall jets

Published online by Cambridge University Press:  20 April 2006

T. Dakos
Affiliation:
Fluids Section, Mechanical Engineering Department, Imperial College of Science and Technology, Exhibition Road, London SW7 2BX
C. A. Verriopoulos
Affiliation:
Fluids Section, Mechanical Engineering Department, Imperial College of Science and Technology, Exhibition Road, London SW7 2BX
M. M. Gibson
Affiliation:
Fluids Section, Mechanical Engineering Department, Imperial College of Science and Technology, Exhibition Road, London SW7 2BX

Abstract

Extensive single-point turbulence measurements made in a heated wall jet on a convex wall, and in an equivalent plane flow, show that the turbulence structure and the transfer of heat and momentum are affected by wall curvature. In the curved wall jet the points of zero shear stress and zero streamwise heat flux are displaced further from the point of maximum velocity, the Stanton number for heat transfer from the surface is reduced more than the skin-friction coefficient, and temperature profiles in the inner layer depart from the flat-flow wall law. The shear stress, turbulent intensities and turbulent heat fluxes are reduced by stabilizing curvature in the inner layer and increased by destabilizing curvature in the outer flow. The largest changes occur in the triple products, which are nearly doubled by destabilizing curvature.

Information

Type
Research Article
Copyright
© 1984 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable