Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-18T01:11:25.496Z Has data issue: false hasContentIssue false

Adhesion and short-range forces between surfaces. Part II: Effects of surface lattice mismatch

Published online by Cambridge University Press:  31 January 2011

Patricia M. McGuiggan
Affiliation:
Materials Department, and Department of Chemical and Nuclear Engineering, University of California, Santa Barbara, California 93106
Jacob N. Israelachvili
Affiliation:
Materials Department, and Department of Chemical and Nuclear Engineering, University of California, Santa Barbara, California 93106
Get access

Abstract

The adhesion forces and interaction potentials between two mica surfaces as a function of the orientation (twist angle) of their surface lattices are reported. The forces were measured in air, in water, and in an aqueous KCl solution where oscillatory structural forces are present. In air, the adhesion is relatively independent of the twist angle θ in the range −10° < θ < +10° due to a 0.4 nm thick amorphous layer at the interface. In water, apart from a relatively angle-independent baseline adhesion, a sharp adhesion peak (energy minimum) occurs at θ = 0°, corresponding to maximum alignment of the surface lattices. As little as ±1° away from this peak the energy decreases by 50%. In aqueous KCl solution, due to potassium ion adsorption the water between the surfaces becomes ordered, resulting in an oscillatory structural force where the adhesive minima occur at discrete separations corresponding to an integral number of water layers. The adhesion energies corresponding to the first three potential minima were angle dependent near θ = 0° (again decreasing by 50% at ±1° away from θ = 0°). The repulsive maxima were also affected near θ = 0°. The results show that the whole interaction potential between two surfaces in liquids depends on the orientation of the surface lattices, and that these effects can extend at least four molecular layers. We discuss the consequences of these findings for material properties such as grain boundary energies, cracks, and friction.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 1990

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable