Hostname: page-component-7b7567c8c-9cwtv Total loading time: 0 Render date: 2026-11-19T19:31:47.949Z Has data issue: false hasContentIssue false

Characterization of hydrated silicate glass microballoons

Published online by Cambridge University Press:  31 January 2011

Hiroshi Isobe
Affiliation:
Technical Center, Fuji Chemical Co., Ltd., Nakatsugawa 509–91, Japan
Ichiro Tokunaga
Affiliation:
Department of Chemistry, Faculty of Science, Chiba University, Chiba 263, Japan
Noriyoshi Nagai
Affiliation:
Department of Chemistry, Faculty of Science, Chiba University, Chiba 263, Japan
Katsumi Kaneko
Affiliation:
Department of Chemistry, Faculty of Science, Chiba University, Chiba 263, Japan
Get access

Abstract

Glass microballoons (GB) of about 1 μm in diameter were prepared by ultrasonic spray pyrolysis from sodium silicate solution. A silica-rich type of glass microballoons (SB) was prepared by acid treatment of GB. The structural changes of both microballoons with thermal treatment up to 973 K were examined. Both GB and SB showed properties similar to hydrated sodium silicate glass, to some extent. SB was more thermally stable than GB, but the spherical structures of both microballoons were collapsed by heating at 973 K; cristobalite was observed in samples heated at 973 K. The loosely and tightly incorporated water molecules evolved up to 573 K and near 850 K, respectively. The crystallization of cristobalite caused tightly incorporated water molecules to develop. The ultramicropores accessible only to H2O molecules in SB gradually decreased by heating and disappeared by heating at 773 K.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 1996

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable