Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-17T06:36:14.740Z Has data issue: false hasContentIssue false

Compressive failure of hydrogel spheres

Published online by Cambridge University Press:  22 May 2020

Jeremiah D. James
Affiliation:
Department of Engineering, East Carolina University, Greenville, North Carolina 27858, USA
Jacob M. Ludwick
Affiliation:
Department of Engineering, East Carolina University, Greenville, North Carolina 27858, USA
Mackenzie L. Wheeler
Affiliation:
Department of Engineering, East Carolina University, Greenville, North Carolina 27858, USA
Michelle L. Oyen*
Affiliation:
Department of Engineering, East Carolina University, Greenville, North Carolina 27858, USA
*
a)Address all correspondence to this author. e-mail: oyenm18@ecu.edu
Get access

Abstract

Hydrogels have gained recent attention for biomedical applications because of their large water content, which imparts biocompatibility. However, their mechanical properties can be limiting. There has been significant recent interest in the strength and fracture toughness of hydrogel materials in addition to their stiffness and time-dependent behavior. Hydrogels can fail in a brittle manner, although they are extremely compliant. In this work, the failure and fracture of hydrogels are examined using a compression test of spherical hydrogel particles. Spheres of commercially available polyacrylamide–potassium polyacrylate were hydrated and tested to failure in compression as a function of loading rate. The spheres exhibited little relaxation when compressed to small fixed displacements. The distributions of strength values obtained were examined in a particle fracture framework previously used for brittle ceramics. There was loading rate dependence apparent in the measured peak force and calculated peak strength values, but the data fell on a single empirical distribution function of strength for the hydrogels regardless of loading rate. Strength values for these hydrogels were mostly in the range of 0.05–0.3 MPa, illustrating the challenges using hydrogels for mechanically demanding applications such as tissue engineering.

Information

Type
Invited Feature Paper
Copyright
Copyright © Materials Research Society 2020

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable

James et al. supplementary material

James et al. supplementary material 1

Download James et al. supplementary material(Video)
Video 16.1 MB

James et al. supplementary material

James et al. supplementary material 2

Download James et al. supplementary material(Video)
Video 77.5 MB