Hostname: page-component-7b7567c8c-tnkh4 Total loading time: 0 Render date: 2026-11-18T10:23:40.339Z Has data issue: false hasContentIssue false

Deformation-induced nanocrystallization: A comparison of two amorphous Al-based alloys

Published online by Cambridge University Press:  01 March 2005

W.H. Jiang
Affiliation:
Department of Nuclear Engineering and Radiological Sciences, University of Michigan, Ann Arbor, Michigan 48109
F.E. Pinkerton
Affiliation:
General Motors R & D Center, Warren, Michigan 48090
M. Atzmon
Affiliation:
Department of Nuclear Engineering and Radiological Sciences, and Department of Materials Science and Engineering, University of Michigan, Ann Arbor, Michigan 48109
Get access

Abstract

Using conventional and high-resolution transmission electron microscopy (HRTEM), the effects of rolling at room temperature on the microstructures of amorphous Al90Fe5Gd5 and Al86.8Ni3.7Y9.5 were compared. In rolled Al90Fe5Gd5, nanocrystallites were observed at shear bands, whereas none were observed in rolled Al86.8Ni3.7Y9.5. When HRTEM was combined with with Fourier transform filtering, nanoscale, low-density defects were imaged. In Al90Fe5Gd5, the shear bands contain few defects, which are concentrated at the boundary zone between the shear bands and undeformed region, whereas in Al86.8Ni3.7Y9.5, the shear bands contain a uniform distribution of defects with a density higher than the undeformed region. The preferential precipitation of nanocrystallites in rolled Al90Fe5Gd5 is attributed to a kinetic effect due to uniformly-distributed excess free volume in the shear bands.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 2005

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable