Hostname: page-component-7b7567c8c-7pwfn Total loading time: 0 Render date: 2026-11-16T10:59:20.435Z Has data issue: false hasContentIssue false

Epitaxy and defects in laser-irradiated, single-crystal bismuth

Published online by Cambridge University Press:  31 January 2011

Aubrey L. Helms Jr.
Affiliation:
AT & T Engineering Research Center, P.O. Box 900, Princeton, New Jersey 08540
Clifton W. Draper
Affiliation:
AT & T Engineering Research Center, P.O. Box 900, Princeton, New Jersey 08540
Dale C. Jacobson
Affiliation:
AT & T Bell Laboratories, 600 Mountain Avenue, Murray Hill, New Jersey 07974
John M. Poate
Affiliation:
AT & T Bell Laboratories, 600 Mountain Avenue, Murray Hill, New Jersey 07974
Steven L. Bernasek
Affiliation:
Department of Chemistry, Frick Chemical Laboratory, Princeton University, Princeton, New Jersey 08544
Get access

Abstract

The (0001), (1010), and (2110) faces of Bi have been pulsed laser irradiated at 0.5–0.8 J/cm2 with a Q-switched ruby laser. Nomarski interference contrast microscopy, channeling, and selective chemical etching have been used to investigate the response of the material to the laser irradiation. The response of Bi is shown to be strongly orientation dependent. The χmin and half-angle for the Bi (0001) surface have been measured and compared to theoretical values. The Bi(0001) surface has been shown to regrow epitaxially without an increase in the disorder. In contrast, the epitaxial regrowth of the Bi(1010) and Bi(2110) surfaces show a marked increase in disorder after irradiation. The levels of damage show a strong correlation to the critical resolved shear stress characteristics in the particular crystallographic orientation studied.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 1988

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable