Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-17T03:05:50.992Z Has data issue: false hasContentIssue false

Experimental method to account for structural compliance in nanoindentation measurements

Published online by Cambridge University Press:  31 January 2011

J.E. Jakes*
Affiliation:
Materials Science Program, University of Wisconsin—Madison, Madison, Wisconsin 53706; and United States Department of Agriculture (USDA) Forest Products Laboratory, Madison, Wisconsin 53726
C.R. Frihart
Affiliation:
United States Department of Agriculture (USDA) Forest Products Laboratory, Madison, Wisconsin 53726
J.F. Beecher
Affiliation:
United States Department of Agriculture (USDA) Forest Products Laboratory, Madison, Wisconsin 53726
R.J. Moon
Affiliation:
United States Department of Agriculture (USDA) Forest Products Laboratory, Madison, Wisconsin 53726
D.S. Stone
Affiliation:
Materials Science Program, University of Wisconsin—Madison, Madison, Wisconsin 53706; and Department of Materials Science and Engineering, University of Wisconsin—Madison, Madison, Wisconsin 53706
*
a)Address all correspondence to this author. e-mail: jjakes@fs.fed.us
Get access

Abstract

The standard Oliver–Pharr nanoindentation analysis tacitly assumes that the specimen is structurally rigid and that it is both semi-infinite and homogeneous. Many specimens violate these assumptions. We show that when the specimen flexes or possesses heterogeneities, such as free edges or interfaces between regions of different properties, artifacts arise in the standard analysis that affect the measurement of hardness and modulus. The origin of these artifacts is a structural compliance (Cs), which adds to the machine compliance (Cm), but unlike the latter, Cs can vary as a function of position within the specimen. We have developed an experimental approach to isolate and remove Cs. The utility of the method is demonstrated using specimens including (i) a silicon beam, which flexes because it is supported only at the ends, (ii) sites near the free edge of a fused silica calibration standard, (iii) the tracheid walls in unembedded loblolly pine (Pinus taeda), and (iv) the polypropylene matrix in a polypropylene–wood composite.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 2008

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable