Hostname: page-component-7b7567c8c-tnkh4 Total loading time: 0 Render date: 2026-11-16T06:08:27.125Z Has data issue: false hasContentIssue false

Formation of intermetallic compounds at eutectic Sn–Zn–Al solder/Cu interface

Published online by Cambridge University Press:  31 January 2011

Shan-Pu Yu
Affiliation:
Department of Materials Science and Engineering, National Cheng Kung University, 1 Ta-Hsueh Road, Tainan, 80782, Taiwan
Moo-Chin Wang
Affiliation:
Department of Mechanical Engineering, National Kaohsiung University of Applied Sciences, 415 Chien-Kung Road, Kaohsiung, 80782, Taiwan
Min-Hsiung Hon
Affiliation:
Department of Materials Science and Engineering, National Cheng Kung University, 1 Ta-Hsueh Road,Tainan, 80782, Taiwan
Get access

Abstract

The eutectic Sn–Zn–Al solder alloy was used [composition: 91Sn–9(5Al–Zn)] to investigate the intermetallic compounds (IMCs) formed between solder and a Cu substrate. Scanning electron microscope, transmission electron microscope, and electron diffraction analysis were used to study the IMCs between solder and a Cu substrate. The γ–Cu5Zn8 and γ–Cu9Al4 IMCs were found at the Sn–Zn–Al/Cu interface. Thermodynamic calculation can explain the formation of γ–Cu5Zn8 and γ–Cu9Al4 IMCs instead of Cu–Sn compounds. The formation and growth of γ–Cu9Al4 IMC at 423 K resulted in the decrease of adhesion strength at the interface of solder and a Cu substrate, where the Kirkendall voids were severely formed. As the heating time increased up to 1000 h at 423 K, the adhesion strength between the eutectic Sn–Zn–Al solder and a Cu substrate decreased from 7.6 ± 0.7 MPa to 4.4 ± 0.8 MPa.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 2001

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable