Hostname: page-component-7b7567c8c-7pwfn Total loading time: 0 Render date: 2026-11-16T16:57:39.604Z Has data issue: false hasContentIssue false

Hardness obtained from conical indentations with various cone angles

Published online by Cambridge University Press:  31 January 2011

Yang-Tse Cheng
Affiliation:
Materials and Processes Laboratory, General Motors Research and Development Center, Warren, Michigan 48090
Zhiyong Li
Affiliation:
Materials and Processes Laboratory, General Motors Research and Development Center, Warren, Michigan 48090
Get access

Abstract

The relationship between hardness and cone angle of conical indenters was studied using finite element analysis for elastic–plastic solids with work-hardening. Comparisons were made between the present simulation results, slip line theory, and experimental results. Tabor's concept of representative strain based on indentation experiments in metals (The Hardness of Metals, Oxford, 1951) was shown to be applicable to a wide range of materials. The relative size of plastic zone with respect to the contact radius was found to influence the variation of hardness with indenter cone angle. The method proposed by Atkins and Tabor [J. Mech. Phys. Solids, 13, 149 (1965)] for constructing stress-strain curves using representative strains was also examined, and the conditions under which the method is valid were obtained.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 2000

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable