Hostname: page-component-7b7567c8c-8tzhz Total loading time: 0 Render date: 2026-11-19T21:36:12.991Z Has data issue: false hasContentIssue false

Heteroepitaxial growth of tungsten oxide films on silicon(100) using a BaF2 buffer layer

Published online by Cambridge University Press:  31 January 2011

L.D. Doucette
Affiliation:
Laboratory for Surface Science and Technology, University of Maine, Orono, Maine 04469
F. Santiago
Affiliation:
Naval Surface Warfare Center, Dahlgren Division, Dahlgren, Virginia 22448
S.L. Moran
Affiliation:
Naval Surface Warfare Center, Dahlgren Division, Dahlgren, Virginia 22448
R.J. Lad
Affiliation:
Laboratory for Surface Science and Technology, University of Maine, Orono, Maine 04469
Get access

Abstract

Multidomained heteroepitaxial WO3 films were grown on Si(100) substrates using a (111)-oriented BaF2 buffer layer at the WO3–Si interface. The 30-nm-thick BaF2 layer, grown by very low rate molecular-beam epitaxy, consisted of four equivalent crystalline domains oriented about the BaF2[111] axis, which provided templates for heteroepitaxial WO3 film growth. The WO3 films were grown by electron cyclotron resonance oxygen plasma-assisted electron beam evaporation of a WO3 source, and the temperature range was varied between 25°C and 600°C. At an optimal deposition temperature of approximately 450°C, monoclinic-phase WO3 films were produced, which consisted of coexisting (002), (020), and (200) in-plane orientations with respect to the BaF2(111)/Si(100) substrate. During growth, an interfacial barium tungstate (BaWO4) reaction product formed at the WO3–BaF2 interface. The {112} planes of this BaWO4 layer also have a multidomained heteroepitaxial orientation with respect to the BaF2(111) buffer layer. Postdeposition annealing experiments in air for 24 h at 400°C indicated that the heteroepitaxial BaWO4 and WO3 layers remain stable. A thermodynamic argument is used to explain the BaWO4 interfacial reaction during initial growth stages, and kinetically limited diffusion processes through the BaWO4layer coupled with lattice matching across the WO3–BaWO4 interface are proposed to be responsible for the formation of stable WO3 films at later growth stages.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 2003

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable