Hostname: page-component-7b7567c8c-fvjsw Total loading time: 0 Render date: 2026-11-17T15:21:56.113Z Has data issue: false hasContentIssue false

Highly resistive sputtered ZnO films implanted with copper

Published online by Cambridge University Press:  31 January 2011

M. K. Puchert
Affiliation:
Surface Science and Technology, School of Chemistry, University of New South Wales, Sydney, New South Wales 2052, Australia
A. Hartmann
Affiliation:
Surface Science and Technology, School of Chemistry, University of New South Wales, Sydney, New South Wales 2052, Australia
R. N. Lamb*
Affiliation:
Surface Science and Technology, School of Chemistry, University of New South Wales, Sydney, New South Wales 2052, Australia
J. W. Martin
Affiliation:
School of Physics, University of New South Wales, Sydney, New South Wales 2052, Australia
*
a) Author to whom all correspondence should be addressed.
Get access

Abstract

Polycrystalline (0001)-oriented thin films of ZnO (thickness 120 nm) were deposited by rf magnetron sputtering and post-deposition annealed at 500 °C in oxygen (1 atm). The films were subsequently implanted with copper at doses over the range 1016 to 1017 ions/cm2. X-ray diffraction (XRD) indicates the compressive intrinsic film stress is largely relieved by the preimplantation anneal, and does not change when implanted or when further annealed after implantation, suggesting that the dominant cause of intrinsic stress is the atomic packing density rather than the crystallographic defect density. Resistivity measurements indicate that annealing of pure ZnO films causes the perpendicular resistivity to increase from 1.3 × 105 Ω · cm to 5 × 1010 Ω · cm. Copper implantation results in a lower resistivity of the order of 107 Ω · cm, but subsequent annealing actually increases resistivity beyond that of annealed nonimplanted ZnO to 3 × 1012 Ω · cm. It is proposed that copper increases the resistivity of those annealed films by trapping free electrons with the Cu 3d hole state occurring in CuO (formed predominantly during annealing). In order to check this, the oxidation state of the implanted copper was studied before and after annealing by x-ray photoelectron spectroscopy (XPS) and extended x-ray absorption fine structure (EXAFS). Three oxidation states of copper (Cu0, Cu1+, Cu2+) are detected in the implanted films, and postimplantation annealing results in oxidation of copper to the Cu2+ state, confirming that the presence of CuO in ZnO is associated with increased resistivity.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 1996

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable