Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-17T15:30:37.865Z Has data issue: false hasContentIssue false

Microstructure evolution and mechanical properties of the ZM61 alloy sheets under different pre-rolling and high strain rate rolling temperatures

Published online by Cambridge University Press:  24 June 2020

Hongge Yan
Affiliation:
School of Materials Science and Engineering, Hunan University, Changsha410082, PR ChinaHunan Provincial Key Laboratory of Spray Deposition Technology & Application, Hunan University, Changsha410082, PR China
Qin Wu*
Affiliation:
School of Materials Science and Engineering, Hunan University, Changsha410082, PR ChinaHunan Provincial Key Laboratory of Spray Deposition Technology & Application, Hunan University, Changsha410082, PR China
Jihua Chen*
Affiliation:
School of Materials Science and Engineering, Hunan University, Changsha410082, PR ChinaHunan Provincial Key Laboratory of Spray Deposition Technology & Application, Hunan University, Changsha410082, PR China
Weijun Xia
Affiliation:
School of Materials Science and Engineering, Hunan University, Changsha410082, PR ChinaHunan Provincial Key Laboratory of Spray Deposition Technology & Application, Hunan University, Changsha410082, PR China
Min Song
Affiliation:
State Key Laboratory of Powder Metallurgy, Central South University, Changsha410083, PR China
Bin Su
Affiliation:
School of Materials Science and Engineering, Hunan University, Changsha410082, PR ChinaHunan Provincial Key Laboratory of Spray Deposition Technology & Application, Hunan University, Changsha410082, PR China
Jiang Wu
Affiliation:
School of Materials Science and Engineering, Hunan University, Changsha410082, PR ChinaHunan Provincial Key Laboratory of Spray Deposition Technology & Application, Hunan University, Changsha410082, PR China
*
a)Address all correspondence to these authors. e-mail: 15074991154@163.com
Get access

Abstract

The microstructure evolution, dynamic recrystallization (DRX) and precipitation of the ZM61 alloy sheets prepared with different rolling conditions were studied. The DRX grain sizes (dDRX) at four high strain rate rolling (HSRR) temperatures (275–350 °C) are 1.9, 2.3, 2.6 and 3.1 μm, respectively, while the DRX volume fractions (fVDRX) are 69, 73, 76 and 82%, respectively. 300 °C is selected as the optimal HSRR temperature. The dDRX and fVDRX of the alloys prepared by pre-rolling (PR) at 300 °C + HSRR are 1.0 μm and 91%, respectively. The PR treatment does not change the types of the precipitates but promotes the precipitation. The tensile strength (UTS) of 369 MPa and yield strength (YS) of 261 MPa can be achieved by HSRR at 300 °C, while a further increase in both UTS and YS can be obtained by PR treatment.

Information

Type
Article
Copyright
Copyright © Materials Research Society 2020

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable